From d89293abd95bfd7dd9229087d6c30c1464c5ac83 Mon Sep 17 00:00:00 2001 From: Tejun Heo Date: Thu, 29 Jan 2009 20:31:29 +0900 Subject: [PATCH] libata: fix EH device failure handling The dev->pio_mode > XFER_PIO_0 test is there to avoid unnecessary speed down warning messages but it accidentally disabled SATA link spd down during configuration phase after reset where PIO mode is always zero. This patch fixes the problem by moving the test where it belongs. This makes libata probing sequence behave better when the connection is flaky at higher link speeds which isn't too uncommon for eSATA devices. Signed-off-by: Tejun Heo Signed-off-by: Jeff Garzik --- drivers/ata/libata-eh.c | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/drivers/ata/libata-eh.c b/drivers/ata/libata-eh.c index 8147a838637..c15572d22a3 100644 --- a/drivers/ata/libata-eh.c +++ b/drivers/ata/libata-eh.c @@ -2979,12 +2979,13 @@ static int ata_eh_handle_dev_fail(struct ata_device *dev, int err) /* give it just one more chance */ ehc->tries[dev->devno] = min(ehc->tries[dev->devno], 1); case -EIO: - if (ehc->tries[dev->devno] == 1 && dev->pio_mode > XFER_PIO_0) { + if (ehc->tries[dev->devno] == 1) { /* This is the last chance, better to slow * down than lose it. */ sata_down_spd_limit(ata_dev_phys_link(dev)); - ata_down_xfermask_limit(dev, ATA_DNXFER_PIO); + if (dev->pio_mode > XFER_PIO_0) + ata_down_xfermask_limit(dev, ATA_DNXFER_PIO); } } -- 2.41.1