From d0f9cbd4b29c3d208d6b31519cbb940d98d61e7d Mon Sep 17 00:00:00 2001 From: "Maciej W. Rozycki" Date: Mon, 9 Jun 2008 17:20:03 +0100 Subject: [PATCH] [MIPS] SB1250: Initialize io_map_base Correctly initialize io_map_base for the SB1250 PCI controller as required for proper iomap support. Based on a proposal from Daniel Jacobowitz. Signed-off-by: Maciej W. Rozycki Signed-off-by: Ralf Baechle --- arch/mips/pci/pci-sb1250.c | 8 +++++--- 1 file changed, 5 insertions(+), 3 deletions(-) diff --git a/arch/mips/pci/pci-sb1250.c b/arch/mips/pci/pci-sb1250.c index 42e4d2c800f..2a09ad91ec8 100644 --- a/arch/mips/pci/pci-sb1250.c +++ b/arch/mips/pci/pci-sb1250.c @@ -207,6 +207,7 @@ struct pci_controller sb1250_controller = { static int __init sb1250_pcibios_init(void) { + void __iomem *io_map_base; uint32_t cmdreg; uint64_t reg; extern int pci_probe_only; @@ -253,12 +254,13 @@ static int __init sb1250_pcibios_init(void) * works correctly with most of Linux's drivers. * XXX ehs: Should this happen in PCI Device mode? */ - - set_io_port_base((unsigned long) - ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES, 65536)); isa_slot_offset = (unsigned long) ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES_32, 1024 * 1024); + io_map_base = ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES, 1024 * 1024); + sb1250_controller.io_map_base = io_map_base; + set_io_port_base((unsigned long)io_map_base); + #ifdef CONFIG_SIBYTE_HAS_LDT /* * Also check the LDT bridge's enable, just in case we didn't -- 2.41.1