From 76f73ca1b291a8d014ff0d2d802c817404dd9887 Mon Sep 17 00:00:00 2001 From: Jarod Wilson Date: Mon, 7 Apr 2008 22:32:33 +0200 Subject: [PATCH] firewire: fw-ohci: don't append to AT context when it's not active I finally tracked down the issues with this JMicron PCI-e card in my possession to a failure to comply with section 7.2.3.2 of the OHCI 1.1 specification (thanks to Kristian for the pointer to illustrate that it is indeed a flaw in this card, not the driver). The controller should simply flush the packets we've appended to its AT queue if a bus reset occurs before they've been transmitted and we'll try again, but something goes wrong and the controller winds up hung. However, we can avoid the problem by simply checking if the IntEvent.busReset register had been set before we try appending to the AT context. When busReset is set, the AT context is completely halted until busReset is cleared, so there's no point in appending AT packets until the register is cleared. So at_context_queue_packet() now checks for busReset being set, and bails with an RCODE_GENERATION packet ack, which results in us trying to append the packet again after recognizing the fact there has been a bus reset, and clearing busReset. Signed-off-by: Jarod Wilson Signed-off-by: Stefan Richter --- drivers/firewire/fw-ohci.c | 15 +++++++++++++-- 1 file changed, 13 insertions(+), 2 deletions(-) diff --git a/drivers/firewire/fw-ohci.c b/drivers/firewire/fw-ohci.c index ce18bab3f9d..4789300b824 100644 --- a/drivers/firewire/fw-ohci.c +++ b/drivers/firewire/fw-ohci.c @@ -950,8 +950,19 @@ at_context_queue_packet(struct context *ctx, struct fw_packet *packet) DESCRIPTOR_IRQ_ALWAYS | DESCRIPTOR_BRANCH_ALWAYS); - /* FIXME: Document how the locking works. */ - if (ohci->generation != packet->generation) { + /* + * If the controller and packet generations don't match, we need to + * bail out and try again. If IntEvent.busReset is set, the AT context + * is halted, so appending to the context and trying to run it is + * futile. Most controllers do the right thing and just flush the AT + * queue (per section 7.2.3.2 of the OHCI 1.1 specification), but + * some controllers (like a JMicron JMB381 PCI-e) misbehave and wind + * up stalling out. So we just bail out in software and try again + * later, and everyone is happy. + * FIXME: Document how the locking works. + */ + if (ohci->generation != packet->generation || + reg_read(ohci, OHCI1394_IntEventSet) & OHCI1394_busReset) { if (packet->payload_length > 0) dma_unmap_single(ohci->card.device, payload_bus, packet->payload_length, DMA_TO_DEVICE); -- 2.41.1