From 3ec0d47427be9ff5b82ba5c5e853c691a942ed65 Mon Sep 17 00:00:00 2001
From: Nicolas Pitre <nico@cam.org>
Date: Mon, 2 Mar 2009 23:44:41 -0500
Subject: [PATCH] [ARM] Kirkwood: SheevaPlug USB Power Enable setup

Ideally, the default should be set to 0 and let the EHCI driver turn
it on as needed.  This makes USB usable in the mean time.

Signed-off-by: Nicolas Pitre <nico@marvell.com>
---
 arch/arm/mach-kirkwood/sheevaplug-setup.c | 13 +++++++++++++
 1 file changed, 13 insertions(+)

diff --git a/arch/arm/mach-kirkwood/sheevaplug-setup.c b/arch/arm/mach-kirkwood/sheevaplug-setup.c
index d48989dfe4d..c1cb9f4d346 100644
--- a/arch/arm/mach-kirkwood/sheevaplug-setup.c
+++ b/arch/arm/mach-kirkwood/sheevaplug-setup.c
@@ -14,12 +14,14 @@
 #include <linux/mtd/nand.h>
 #include <linux/mtd/partitions.h>
 #include <linux/mv643xx_eth.h>
+#include <linux/gpio.h>
 #include <asm/mach-types.h>
 #include <asm/mach/arch.h>
 #include <mach/kirkwood.h>
 #include <plat/mvsdio.h>
 #include <plat/orion_nand.h>
 #include "common.h"
+#include "mpp.h"
 
 static struct mtd_partition sheevaplug_nand_parts[] = {
 	{
@@ -71,15 +73,26 @@ static struct mvsdio_platform_data sheevaplug_mvsdio_data = {
 	// unfortunately the CD signal has not been connected */
 };
 
+static unsigned int sheevaplug_mpp_config[] __initdata = {
+	MPP29_GPIO,	/* USB Power Enable */
+	0
+};
+
 static void __init sheevaplug_init(void)
 {
 	/*
 	 * Basic setup. Needs to be called early.
 	 */
 	kirkwood_init();
+	kirkwood_mpp_conf(sheevaplug_mpp_config);
 
 	kirkwood_uart0_init();
+
+	if (gpio_request(29, "USB Power Enable") != 0 ||
+	    gpio_direction_output(29, 1) != 0)
+		printk(KERN_ERR "can't set up GPIO 29 (USB Power Enable)\n");
 	kirkwood_ehci_init();
+
 	kirkwood_ge00_init(&sheevaplug_ge00_data);
 	kirkwood_sdio_init(&sheevaplug_mvsdio_data);
 
-- 
2.41.1