From 28cd4289abc2c8db90344ee4ff064a9bdf086fdf Mon Sep 17 00:00:00 2001 From: Jeff Garzik Date: Fri, 27 Jun 2008 02:18:50 -0400 Subject: [PATCH] [netdrvr] fealnx: clean up nasty mess of arch ifdefs Clean up config/burst value arch-specific setup. * bcrvalue only varied by its big-endian bit * crvalue only varied for certain types of x86-32 chips This should make fealnx quite a bit more portable, without any behavior change. Signed-off-by: Jeff Garzik --- drivers/net/fealnx.c | 43 ++++++++++++------------------------------- 1 file changed, 12 insertions(+), 31 deletions(-) diff --git a/drivers/net/fealnx.c b/drivers/net/fealnx.c index 7bb9c728a1d..3c1364de2b6 100644 --- a/drivers/net/fealnx.c +++ b/drivers/net/fealnx.c @@ -90,6 +90,7 @@ static int full_duplex[MAX_UNITS] = { -1, -1, -1, -1, -1, -1, -1, -1 }; #include /* Processor type for cache alignment. */ #include #include +#include /* These identify the driver base version and may not be removed. */ static char version[] = @@ -861,40 +862,20 @@ static int netdev_open(struct net_device *dev) Wait the specified 50 PCI cycles after a reset by initializing Tx and Rx queues and the address filter list. FIXME (Ueimor): optimistic for alpha + posted writes ? */ -#if defined(__powerpc__) || defined(__sparc__) -// 89/9/1 modify, -// np->bcrvalue=0x04 | 0x0x38; /* big-endian, 256 burst length */ - np->bcrvalue = 0x04 | 0x10; /* big-endian, tx 8 burst length */ - np->crvalue = 0xe00; /* rx 128 burst length */ -#elif defined(__alpha__) || defined(__x86_64__) -// 89/9/1 modify, -// np->bcrvalue=0x38; /* little-endian, 256 burst length */ - np->bcrvalue = 0x10; /* little-endian, 8 burst length */ - np->crvalue = 0xe00; /* rx 128 burst length */ -#elif defined(__i386__) -#if defined(MODULE) -// 89/9/1 modify, -// np->bcrvalue=0x38; /* little-endian, 256 burst length */ + np->bcrvalue = 0x10; /* little-endian, 8 burst length */ - np->crvalue = 0xe00; /* rx 128 burst length */ -#else - /* When not a module we can work around broken '486 PCI boards. */ -#define x86 boot_cpu_data.x86 -// 89/9/1 modify, -// np->bcrvalue=(x86 <= 4 ? 0x10 : 0x38); - np->bcrvalue = 0x10; - np->crvalue = (x86 <= 4 ? 0xa00 : 0xe00); - if (x86 <= 4) - printk(KERN_INFO "%s: This is a 386/486 PCI system, setting burst " - "length to %x.\n", dev->name, (x86 <= 4 ? 0x10 : 0x38)); +#ifdef __BIG_ENDIAN + np->bcrvalue |= 0x04; /* big-endian */ #endif -#else -// 89/9/1 modify, -// np->bcrvalue=0x38; - np->bcrvalue = 0x10; - np->crvalue = 0xe00; /* rx 128 burst length */ -#warning Processor architecture undefined! + +#if defined(__i386__) && !defined(MODULE) + if (boot_cpu_data.x86 <= 4) + np->crvalue = 0xa00; + else #endif + np->crvalue = 0xe00; /* rx 128 burst length */ + + // 89/12/29 add, // 90/1/16 modify, // np->imrvalue=FBE|TUNF|CNTOVF|RBU|TI|RI; -- 2.41.1