From 027da01d734db0ca9dd1a084339dab07ab576935 Mon Sep 17 00:00:00 2001 From: Ben Dooks Date: Mon, 5 Sep 2005 20:47:53 +0100 Subject: [PATCH] [ARM] 2876/1: N30 - remove task to toggle USB D+ line Patch from Ben Dooks The n30 machine file is using a kernel thread to change the state of the USB D+ pull-up resistor, which is not the proper way to do this. Once the usb-gadget support for the 24xx is merge, the proper access method will be added. This patch also removes the problem of using HZ for the msleep calls, from Nishanth Aravamudan. Signed-off-by: Ben Dooks Signed-off-by: Russell King --- arch/arm/mach-s3c2410/mach-n30.c | 30 ++++++++++-------------------- 1 file changed, 10 insertions(+), 20 deletions(-) diff --git a/arch/arm/mach-s3c2410/mach-n30.c b/arch/arm/mach-s3c2410/mach-n30.c index 79044d9bce3..66bf5bb2b3d 100644 --- a/arch/arm/mach-s3c2410/mach-n30.c +++ b/arch/arm/mach-s3c2410/mach-n30.c @@ -110,34 +110,24 @@ void __init n30_init_irq(void) s3c24xx_init_irq(); } - -static int n30_usbstart_thread(void *unused) -{ - /* Turn off suspend on both USB ports, and switch the - * selectable USB port to USB device mode. */ - writel(readl(S3C2410_MISCCR) & ~0x00003008, S3C2410_MISCCR); - - /* Turn off the D+ pull up for 3 seconds so that the USB host - * at the other end will do a rescan of the USB bus. */ - s3c2410_gpio_setpin(S3C2410_GPB3, 0); - - msleep_interruptible(3*HZ); - - s3c2410_gpio_setpin(S3C2410_GPB3, 1); - - return 0; -} - +/* GPB3 is the line that controls the pull-up for the USB D+ line */ void __init n30_init(void) { s3c_device_i2c.dev.platform_data = &n30_i2ccfg; - kthread_run(n30_usbstart_thread, NULL, "n30_usbstart"); + /* Turn off suspend on both USB ports, and switch the + * selectable USB port to USB device mode. */ + + s3c2410_modify_misccr(S3C2410_MISCCR_USBHOST | + S3C2410_MISCCR_USBSUSPND0 | + S3C2410_MISCCR_USBSUSPND1, 0x0); } MACHINE_START(N30, "Acer-N30") - /* Maintainer: Christer Weinigel , Ben Dooks */ + /* Maintainer: Christer Weinigel , + Ben Dooks + */ .phys_ram = S3C2410_SDRAM_PA, .phys_io = S3C2410_PA_UART, .io_pg_offst = (((u32)S3C24XX_VA_UART) >> 18) & 0xfffc, -- 2.41.1