Manu Abraham [Fri, 18 Jan 2008 14:28:48 +0000 (11:28 -0300)]
V4L/DVB (9443): Bug: Bandwidth calculation
Bug #1: The 5 tap equaliser is set to correct simple perturbations
like reflections on the IF cable for DVB-S. In the case of DVB-S2
a more powerful equalizer is used to correct the filter group delay
allowing the bandwidth to be reduced by a factor of 1/3
Bug #2: The ZIF tuner takes badwidth to be set in Hz
Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Manu Abraham [Mon, 19 Nov 2007 19:44:47 +0000 (16:44 -0300)]
V4L/DVB (9442): Revert back previous change to 90MHz
Note:
* At High Symbol Rates we do not have enouph machine cycles to handle the
incoming symbols and hence might run into problems at the very end of the
specified definition
* Most of the equations have been calculated for a master clock of 99 MHz,
running at 90MHz, raises lot of issues such as the need to recalculate
all of them , which is eventually very painful.
Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Manu Abraham [Sat, 10 Nov 2007 19:59:16 +0000 (16:59 -0300)]
V4L/DVB (9441): Code simplification: clock is already initialized, no need to initialize again.
Thanks to Marko Schluessler <marco@lordzodiac.de> for pointing it out
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Arvo Jarve [Tue, 30 Oct 2007 13:21:33 +0000 (10:21 -0300)]
V4L/DVB (9433): Limit bandwidth with a 3dB response fall
In this case, we will be sure that there exists a carrier
and the center frequency would be simply f1 - f2. In such
a circumstance, the TR loop is simplified to doing a simple
check for timing, rather than searching for the same.
Signed-off-by: Arvo Jarve <arvo@softshark.ee> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
BUG! Setting CRL parameter overwrote the CR Algorithm type,
eventually leading to wrong search algorithm to be employed in
the DVB-S carrier loop optimization.
Symptom: Once the CR optimization stage is passed either way, in
a successful or failed manner, the very next carrier search will
fail, due to no Carrier Search Algorithm specified.
Signed-off-by: Arvo Jarve <arvo@softshark.ee> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Manu Abraham [Mon, 15 Oct 2007 17:39:58 +0000 (14:39 -0300)]
V4L/DVB (9423): Though insignificant, removes an unnecessary read of the LOCK_LOSS register,
which should have happenend in the DVB-S2 mode only, but reading it as it is
for the other delivery systems causes nothing to say but LOCK_LOST, which
just causes confusion amongst users.
Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
V4L/DVB (9406): Really silly bug, setting bandwidth into frequency
probably should stop fiddling with code late nights. :-(
Thanks to Marco for pointing it out and fixing it.
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
V4L/DVB (9398): Initial support for the Technotrend TT S2 3200
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Signed-off-by: Marko Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Manu Abraham [Mon, 2 Jul 2007 11:44:32 +0000 (08:44 -0300)]
V4L/DVB (9381): On the KNC1 cards the CLOCK is clamped to a maximum limit of 90MHz, eventhough
not limited in hardware, this causes instabilities at a higher clock due to
issues such as thermal, also the divider wraps around, which causes the
demodulator core to actually run at a lower frequency. This needs to be
empirically tested whether it affects other cards. If found necessary, this
parameter needs to be moved out to the config struct such that it can be made
hardware dependant.
Reducing the CLOCK from 99MHz to 90MHz improved the acquisition time taken on
the KNC1 cards and hence such a change.
Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
s921_module.c:
wrapper for the dvb frontend interface
s921_core.c:
core s921 1seg ISDB-T driver, everything is set to auto as much as possible
in order to not require certain parameters which currently cannot be passed
to the ISDB-T chip.
ISDB-T support can be tested using dvbscan, dvbstream/snoop and mplayer
Tested 1seg H264/aac stream with this driver using a custom linux
ISDB-T player
Issue: Currently, the DVBFE_ALGO_CUSTOM is called only at the first tuning.
After the first call, the status is never set to force a new tuning.
Signed-off-by: Marco Schluessler <marco@lordzodiac.de> Signed-off-by: Manu Abraham <manu@linuxtv.org> Signed-off-by: Mauro Carvalho Chehab <mchehab@redhat.com>
Linus Torvalds [Mon, 29 Dec 2008 00:54:33 +0000 (16:54 -0800)]
Merge branch 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc
* 'next' of git://git.kernel.org/pub/scm/linux/kernel/git/paulus/powerpc: (144 commits)
powerpc/44x: Support 16K/64K base page sizes on 44x
powerpc: Force memory size to be a multiple of PAGE_SIZE
powerpc/32: Wire up the trampoline code for kdump
powerpc/32: Add the ability for a classic ppc kernel to be loaded at 32M
powerpc/32: Allow __ioremap on RAM addresses for kdump kernel
powerpc/32: Setup OF properties for kdump
powerpc/32/kdump: Implement crash_setup_regs() using ppc_save_regs()
powerpc: Prepare xmon_save_regs for use with kdump
powerpc: Remove default kexec/crash_kernel ops assignments
powerpc: Make default kexec/crash_kernel ops implicit
powerpc: Setup OF properties for ppc32 kexec
powerpc/pseries: Fix cpu hotplug
powerpc: Fix KVM build on ppc440
powerpc/cell: add QPACE as a separate Cell platform
powerpc/cell: fix build breakage with CONFIG_SPUFS disabled
powerpc/mpc5200: fix error paths in PSC UART probe function
powerpc/mpc5200: add rts/cts handling in PSC UART driver
powerpc/mpc5200: Make PSC UART driver update serial errors counters
powerpc/mpc5200: Remove obsolete code from mpc5200 MDIO driver
powerpc/mpc5200: Add MDMA/UDMA support to MPC5200 ATA driver
...
Fix trivial conflict in drivers/char/Makefile as per Paul's directions
Linus Torvalds [Sun, 28 Dec 2008 23:15:08 +0000 (15:15 -0800)]
Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jmorris/security-testing-2.6
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/jmorris/security-testing-2.6:
smackfs: check for allocation failures in smk_set_access()
* git://git.kernel.org/pub/scm/linux/kernel/git/sam/kbuild-next: (25 commits)
allow stripping of generated symbols under CONFIG_KALLSYMS_ALL
kbuild: strip generated symbols from *.ko
kbuild: simplify use of genksyms
kernel-doc: check for extra kernel-doc notations
kbuild: add headerdep used to detect inclusion cycles in header files
kbuild: fix string equality testing in tags.sh
kbuild: fix make tags/cscope
kbuild: fix make incompatibility
kbuild: remove TAR_IGNORE
setlocalversion: add git-svn support
setlocalversion: print correct subversion revision
scripts: improve the decodecode script
scripts/package: allow custom options to rpm
genksyms: allow to ignore symbol checksum changes
genksyms: track symbol checksum changes
tags and cscope support really belongs in a shell script
kconfig: fix options to check-lxdialog.sh
kbuild: gen_init_cpio expands shell variables in file names
remove bashisms from scripts/extract-ikconfig
kbuild: teach mkmakfile to be silent
...
Ilya Yanok [Thu, 11 Dec 2008 01:55:41 +0000 (04:55 +0300)]
powerpc/44x: Support 16K/64K base page sizes on 44x
This adds support for 16k and 64k page sizes on PowerPC 44x processors.
The PGDIR table is much smaller than a page when using 16k or 64k
pages (512 and 32 bytes respectively) so we allocate the PGDIR with
kzalloc() instead of __get_free_pages().
One PTE table covers rather a large memory area when using 16k or 64k
pages (32MB or 512MB respectively), so we can easily put FIXMAP and
PKMAP in the area covered by one PTE table.
Signed-off-by: Yuri Tikhonov <yur@emcraft.com> Signed-off-by: Vladimir Panfilov <pvr@emcraft.com> Signed-off-by: Ilya Yanok <yanok@emcraft.com> Acked-by: Josh Boyer <jwboyer@linux.vnet.ibm.com> Signed-off-by: Paul Mackerras <paulus@samba.org>
Hollis Blanchard [Wed, 26 Nov 2008 16:19:26 +0000 (10:19 -0600)]
powerpc: Force memory size to be a multiple of PAGE_SIZE
Ensure that total memory size is page-aligned, because otherwise
mark_bootmem() gets upset.
This error case was triggered by using 64 KiB pages in the kernel
while arch/powerpc/boot/4xx.c arbitrarily reduced the amount of memory
by 4096 (to work around a chip bug that affects the last 256 bytes of
physical memory).
Signed-off-by: Hollis Blanchard <hollisb@us.ibm.com> Signed-off-by: Paul Mackerras <paulus@samba.org>
Linus Torvalds [Sun, 28 Dec 2008 20:54:07 +0000 (12:54 -0800)]
Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k
* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/geert/linux-m68k:
m68k: use the new byteorder headers
fbcon: Protect free_irq() by MACH_IS_ATARI check
fbcon: remove broken mac vbl handler
m68k: fix trigraph ignored warning in setox.S
macfb annotations and compiler warning fix
m68k: mac baboon interrupt enable/disable
m68k: machw.h cleanup
m68k: Mac via cleanup and commentry
m68k: Reinstate mac rtc
projects / linux-2.6-omap-h63xx.git / log