From: Stefan Richter Date: Sat, 1 Mar 2008 11:34:50 +0000 (+0100) Subject: firewire: fw-ohci: switch on bus power after resume on PPC PMac X-Git-Tag: v2.6.26-rc1~1141^2~20 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=eb5ca72effaa7f691f7df5187c5c5d1268311326;p=linux-2.6-omap-h63xx.git firewire: fw-ohci: switch on bus power after resume on PPC PMac The platform feature calls in the suspend method switched off cable power, but the calls in the resume method did not switch it back on. Add the necessary feature call to .resume. Also add the corresponding call to .suspend to make .suspend's behavior explicitly the same on all PMacs. Signed-off-by: Stefan Richter --- diff --git a/drivers/firewire/fw-ohci.c b/drivers/firewire/fw-ohci.c index 5da7c6715e1..312182d6d97 100644 --- a/drivers/firewire/fw-ohci.c +++ b/drivers/firewire/fw-ohci.c @@ -2251,8 +2251,10 @@ static int pci_suspend(struct pci_dev *pdev, pm_message_t state) if (machine_is(powermac)) { struct device_node *ofn = pci_device_to_OF_node(pdev); - if (ofn) + if (ofn) { pmac_call_feature(PMAC_FTR_1394_ENABLE, ofn, 0, 0); + pmac_call_feature(PMAC_FTR_1394_CABLE_POWER, ofn, 0, 0); + } } #endif /* CONFIG_PPC_PMAC */ @@ -2269,8 +2271,10 @@ static int pci_resume(struct pci_dev *pdev) if (machine_is(powermac)) { struct device_node *ofn = pci_device_to_OF_node(pdev); - if (ofn) + if (ofn) { + pmac_call_feature(PMAC_FTR_1394_CABLE_POWER, ofn, 0, 1); pmac_call_feature(PMAC_FTR_1394_ENABLE, ofn, 0, 1); + } } #endif /* CONFIG_PPC_PMAC */