From: Christian Lamparter Date: Wed, 13 Aug 2008 21:41:48 +0000 (+0200) Subject: p54u: reset skb's data/tail pointer on requeue X-Git-Tag: v2.6.27-rc4~39^2~10^2~4 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=d47c3cebf5aae9d72b2cc18e5ac3b520fdbb0bca;p=linux-2.6-omap-h63xx.git p54u: reset skb's data/tail pointer on requeue (Only important for USB V1 Adaptors) If an incoming frame wasn't accepted by p54_rx function the skb will be reused for new frames... But, we must not forget to set the skb's data pointers into the same state in which it was initialized by p54u_init_urbs. Otherwise we either end up with 16 bytes less on every requeue, or if a new frame is worthy enough to be accepted, the data is in the wrong place (urb->transfer_buffer wasn't updated!) and mac80211 has a hard time to recognize it... Signed-off-by: Christian Lamparter Signed-off-by: John W. Linville --- diff --git a/drivers/net/wireless/p54/p54usb.c b/drivers/net/wireless/p54/p54usb.c index 815c095ef79..cbaca23a945 100644 --- a/drivers/net/wireless/p54/p54usb.c +++ b/drivers/net/wireless/p54/p54usb.c @@ -109,7 +109,17 @@ static void p54u_rx_cb(struct urb *urb) urb->context = skb; skb_queue_tail(&priv->rx_queue, skb); } else { + if (!priv->hw_type) + skb_push(skb, sizeof(struct net2280_tx_hdr)); + + skb_reset_tail_pointer(skb); skb_trim(skb, 0); + if (urb->transfer_buffer != skb_tail_pointer(skb)) { + /* this should not happen */ + WARN_ON(1); + urb->transfer_buffer = skb_tail_pointer(skb); + } + skb_queue_tail(&priv->rx_queue, skb); }