From: David Woodhouse Date: Sat, 6 May 2006 18:47:57 +0000 (+0100) Subject: Revert include/media changes: Mauro says those ioctls are only used in-kernel(!) X-Git-Tag: v2.6.18-rc1~1103^2~8 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=c0f1fe00c3923135b2c2f443448585482da8a53e;p=linux-2.6-omap-h63xx.git Revert include/media changes: Mauro says those ioctls are only used in-kernel(!) Reverts commit eba7f3bdb6344adee8a3d044f405ed38f5c66c6b Signed-off-by: David Woodhouse --- diff --git a/include/media/v4l2-common.h b/include/media/v4l2-common.h index daa2de1784f..642520acdfa 100644 --- a/include/media/v4l2-common.h +++ b/include/media/v4l2-common.h @@ -82,19 +82,19 @@ extern void v4l_printk_ioctl_arg(char *s,unsigned int cmd, void *arg); /* VIDIOC_INT_G_REGISTER and VIDIOC_INT_S_REGISTER */ struct v4l2_register { - __u32 i2c_id; /* I2C driver ID of the I2C chip. 0 for the I2C adapter. */ + u32 i2c_id; /* I2C driver ID of the I2C chip. 0 for the I2C adapter. */ unsigned long reg; - __u32 val; + u32 val; }; /* VIDIOC_INT_DECODE_VBI_LINE */ struct v4l2_decode_vbi_line { - __u32 is_second_field; /* Set to 0 for the first (odd) field, + u32 is_second_field; /* Set to 0 for the first (odd) field, set to 1 for the second (even) field. */ - __u8 *p; /* Pointer to the sliced VBI data from the decoder. + u8 *p; /* Pointer to the sliced VBI data from the decoder. On exit points to the start of the payload. */ - __u32 line; /* Line number of the sliced VBI data (1-23) */ - __u32 type; /* VBI service type (V4L2_SLICED_*). 0 if no service found */ + u32 line; /* Line number of the sliced VBI data (1-23) */ + u32 type; /* VBI service type (V4L2_SLICED_*). 0 if no service found */ }; /* VIDIOC_INT_G_CHIP_IDENT: identifies the actual chip installed on the board */ @@ -193,8 +193,8 @@ enum v4l2_chip_ident { /* Routing definition, device dependent. It specifies which inputs (if any) should be routed to which outputs (if any). */ struct v4l2_routing { - __u32 input; - __u32 output; + u32 input; + u32 output; }; /* These internal commands should be used to define the inputs and outputs