From: Jeff Kirsher Date: Fri, 13 Jan 2006 00:50:30 +0000 (-0800) Subject: [PATCH] e1000: Fix ASF/AMT for 8257{1|2|3} controllers X-Git-Tag: v2.6.16-rc2~366^2~46 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=b55ccb356167ed2d2d40b9dc0fe05bbe1a3d6f39;p=linux-2.6-omap-h63xx.git [PATCH] e1000: Fix ASF/AMT for 8257{1|2|3} controllers The 82573 controller required different logic than 82571|2 controllers. Corrected the reset logic for 8257{1|2|3} controllers. Signed-off-by: Jeff Kirsher Signed-off-by: Jesse Brandeburg Signed-off-by: John Ronciak Signed-off-by: Jeff Garzik --- diff --git a/drivers/net/e1000/e1000_hw.c b/drivers/net/e1000/e1000_hw.c index 136fc031e4a..f853e1064ac 100644 --- a/drivers/net/e1000/e1000_hw.c +++ b/drivers/net/e1000/e1000_hw.c @@ -2982,6 +2982,8 @@ e1000_phy_hw_reset(struct e1000_hw *hw) if (hw->mac_type < e1000_82571) msec_delay(10); + else + udelay(100); E1000_WRITE_REG(hw, CTRL, ctrl); E1000_WRITE_FLUSH(hw); diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c index 66cf1748ba9..5b4287163e0 100644 --- a/drivers/net/e1000/e1000_main.c +++ b/drivers/net/e1000/e1000_main.c @@ -319,7 +319,75 @@ e1000_update_mng_vlan(struct e1000_adapter *adapter) } } } - + +/** + * e1000_release_hw_control - release control of the h/w to f/w + * @adapter: address of board private structure + * + * e1000_release_hw_control resets {CTRL_EXT|FWSM}:DRV_LOAD bit. + * For ASF and Pass Through versions of f/w this means that the + * driver is no longer loaded. For AMT version (only with 82573) i + * of the f/w this means that the netowrk i/f is closed. + * + **/ + +static inline void +e1000_release_hw_control(struct e1000_adapter *adapter) +{ + uint32_t ctrl_ext; + uint32_t swsm; + + /* Let firmware taken over control of h/w */ + switch (adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD); + break; + case e1000_82573: + swsm = E1000_READ_REG(&adapter->hw, SWSM); + E1000_WRITE_REG(&adapter->hw, SWSM, + swsm & ~E1000_SWSM_DRV_LOAD); + default: + break; + } +} + +/** + * e1000_get_hw_control - get control of the h/w from f/w + * @adapter: address of board private structure + * + * e1000_get_hw_control sets {CTRL_EXT|FWSM}:DRV_LOAD bit. + * For ASF and Pass Through versions of f/w this means that + * the driver is loaded. For AMT version (only with 82573) + * of the f/w this means that the netowrk i/f is open. + * + **/ + +static inline void +e1000_get_hw_control(struct e1000_adapter *adapter) +{ + uint32_t ctrl_ext; + uint32_t swsm; + /* Let firmware know the driver has taken over */ + switch (adapter->hw.mac_type) { + case e1000_82571: + case e1000_82572: + ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); + E1000_WRITE_REG(&adapter->hw, CTRL_EXT, + ctrl_ext | E1000_CTRL_EXT_DRV_LOAD); + break; + case e1000_82573: + swsm = E1000_READ_REG(&adapter->hw, SWSM); + E1000_WRITE_REG(&adapter->hw, SWSM, + swsm | E1000_SWSM_DRV_LOAD); + break; + default: + break; + } +} + int e1000_up(struct e1000_adapter *adapter) { @@ -523,8 +591,6 @@ e1000_probe(struct pci_dev *pdev, struct net_device *netdev; struct e1000_adapter *adapter; unsigned long mmio_start, mmio_len; - uint32_t ctrl_ext; - uint32_t swsm; static int cards_found = 0; int i, err, pci_using_dac; @@ -736,22 +802,13 @@ e1000_probe(struct pci_dev *pdev, /* reset the hardware with the new settings */ e1000_reset(adapter); - /* Let firmware know the driver has taken over */ - switch(adapter->hw.mac_type) { - case e1000_82571: - case e1000_82572: - ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); - E1000_WRITE_REG(&adapter->hw, CTRL_EXT, - ctrl_ext | E1000_CTRL_EXT_DRV_LOAD); - break; - case e1000_82573: - swsm = E1000_READ_REG(&adapter->hw, SWSM); - E1000_WRITE_REG(&adapter->hw, SWSM, - swsm | E1000_SWSM_DRV_LOAD); - break; - default: - break; - } + /* If the controller is 82573 and f/w is AMT, do not set + * DRV_LOAD until the interface is up. For all other cases, + * let the f/w know that the h/w is now under the control + * of the driver. */ + if (adapter->hw.mac_type != e1000_82573 || + !e1000_check_mng_mode(&adapter->hw)) + e1000_get_hw_control(adapter); strcpy(netdev->name, "eth%d"); if((err = register_netdev(netdev))) @@ -788,8 +845,7 @@ e1000_remove(struct pci_dev *pdev) { struct net_device *netdev = pci_get_drvdata(pdev); struct e1000_adapter *adapter = netdev_priv(netdev); - uint32_t ctrl_ext; - uint32_t manc, swsm; + uint32_t manc; #ifdef CONFIG_E1000_NAPI int i; #endif @@ -805,22 +861,9 @@ e1000_remove(struct pci_dev *pdev) } } - switch(adapter->hw.mac_type) { - case e1000_82571: - case e1000_82572: - ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); - E1000_WRITE_REG(&adapter->hw, CTRL_EXT, - ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD); - break; - case e1000_82573: - swsm = E1000_READ_REG(&adapter->hw, SWSM); - E1000_WRITE_REG(&adapter->hw, SWSM, - swsm & ~E1000_SWSM_DRV_LOAD); - break; - - default: - break; - } + /* Release control of h/w to f/w. If f/w is AMT enabled, this + * would have already happened in close and is redundant. */ + e1000_release_hw_control(adapter); unregister_netdev(netdev); #ifdef CONFIG_E1000_NAPI @@ -1077,6 +1120,12 @@ e1000_open(struct net_device *netdev) e1000_update_mng_vlan(adapter); } + /* If AMT is enabled, let the firmware know that the network + * interface is now open */ + if (adapter->hw.mac_type == e1000_82573 && + e1000_check_mng_mode(&adapter->hw)) + e1000_get_hw_control(adapter); + return E1000_SUCCESS; err_up: @@ -1115,6 +1164,13 @@ e1000_close(struct net_device *netdev) E1000_MNG_DHCP_COOKIE_STATUS_VLAN_SUPPORT)) { e1000_vlan_rx_kill_vid(netdev, adapter->mng_vlan_id); } + + /* If AMT is enabled, let the firmware know that the network + * interface is now closed */ + if (adapter->hw.mac_type == e1000_82573 && + e1000_check_mng_mode(&adapter->hw)) + e1000_release_hw_control(adapter); + return 0; } @@ -4182,7 +4238,7 @@ e1000_suspend(struct pci_dev *pdev, pm_message_t state) { struct net_device *netdev = pci_get_drvdata(pdev); struct e1000_adapter *adapter = netdev_priv(netdev); - uint32_t ctrl, ctrl_ext, rctl, manc, status, swsm; + uint32_t ctrl, ctrl_ext, rctl, manc, status; uint32_t wufc = adapter->wol; netif_device_detach(netdev); @@ -4251,21 +4307,9 @@ e1000_suspend(struct pci_dev *pdev, pm_message_t state) } } - switch(adapter->hw.mac_type) { - case e1000_82571: - case e1000_82572: - ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); - E1000_WRITE_REG(&adapter->hw, CTRL_EXT, - ctrl_ext & ~E1000_CTRL_EXT_DRV_LOAD); - break; - case e1000_82573: - swsm = E1000_READ_REG(&adapter->hw, SWSM); - E1000_WRITE_REG(&adapter->hw, SWSM, - swsm & ~E1000_SWSM_DRV_LOAD); - break; - default: - break; - } + /* Release control of h/w to f/w. If f/w is AMT enabled, this + * would have already happened in close and is redundant. */ + e1000_release_hw_control(adapter); pci_disable_device(pdev); pci_set_power_state(pdev, pci_choose_state(pdev, state)); @@ -4278,8 +4322,7 @@ e1000_resume(struct pci_dev *pdev) { struct net_device *netdev = pci_get_drvdata(pdev); struct e1000_adapter *adapter = netdev_priv(netdev); - uint32_t manc, ret_val, swsm; - uint32_t ctrl_ext; + uint32_t manc, ret_val; pci_set_power_state(pdev, PCI_D0); pci_restore_state(pdev); @@ -4304,21 +4347,13 @@ e1000_resume(struct pci_dev *pdev) E1000_WRITE_REG(&adapter->hw, MANC, manc); } - switch(adapter->hw.mac_type) { - case e1000_82571: - case e1000_82572: - ctrl_ext = E1000_READ_REG(&adapter->hw, CTRL_EXT); - E1000_WRITE_REG(&adapter->hw, CTRL_EXT, - ctrl_ext | E1000_CTRL_EXT_DRV_LOAD); - break; - case e1000_82573: - swsm = E1000_READ_REG(&adapter->hw, SWSM); - E1000_WRITE_REG(&adapter->hw, SWSM, - swsm | E1000_SWSM_DRV_LOAD); - break; - default: - break; - } + /* If the controller is 82573 and f/w is AMT, do not set + * DRV_LOAD until the interface is up. For all other cases, + * let the f/w know that the h/w is now under the control + * of the driver. */ + if (adapter->hw.mac_type != e1000_82573 || + !e1000_check_mng_mode(&adapter->hw)) + e1000_get_hw_control(adapter); return 0; }