From: Andy Gospodarek Date: Thu, 19 Jun 2008 21:19:12 +0000 (-0400) Subject: e1000: remove e1000_clean_tx_irq call from e1000_netpoll X-Git-Tag: v2.6.27-rc1~969^2~255^2~8 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=b45f87681e2851f0c991a589989daa6a4a351565;p=linux-2.6-omap-h63xx.git e1000: remove e1000_clean_tx_irq call from e1000_netpoll The call to e1000_clean_tx_irq in e1000_netpoll can race with the call to e1000_clean_tx_irq in e1000_clean. With a small bit of tweaking to to netpoll_send_skb to simulate a system that was under extreme stress, I was able to reproduce these concurrent calls. This can result in multiple frees to the skbs on the tx ring buffer. Dropping this call from e1000_netpoll should be fine since we can rely on the calls in e1000_clean to do what is needed since napi will poll the hardware just after calling poll_controller. Signed-off-by: Andy Gospodarek Signed-off-by: Jeff Garzik --- diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c index b0e2493085b..311ca266bd7 100644 --- a/drivers/net/e1000/e1000_main.c +++ b/drivers/net/e1000/e1000_main.c @@ -5251,7 +5251,6 @@ e1000_netpoll(struct net_device *netdev) disable_irq(adapter->pdev->irq); e1000_intr(adapter->pdev->irq, netdev); - e1000_clean_tx_irq(adapter, adapter->tx_ring); #ifndef CONFIG_E1000_NAPI adapter->clean_rx(adapter, adapter->rx_ring); #endif