From: Bartlomiej Zolnierkiewicz Date: Sat, 22 Mar 2008 15:40:21 +0000 (+0100) Subject: ide: Documentation/ide/ide.txt fixes X-Git-Tag: v2.6.25-rc7~30^2~3 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=ad1c53bcdb831e14b1313ad694d5053ae0349393;p=linux-2.6-omap-h63xx.git ide: Documentation/ide/ide.txt fixes * "hdx=cyls,heads,sects,wpcom,irq" should be "hdx=cyls,heads,sects". * "hdx=" is for "x" from 'a' to 'u', "idex=" is for "x" from '0' to '9'. * "idex=noautotune" is long gone. * Obsoleted "ide0=" parameters were already removed from the documentation. Signed-off-by: Bartlomiej Zolnierkiewicz --- diff --git a/Documentation/ide/ide.txt b/Documentation/ide/ide.txt index e3b3425328b..d4877a9e60f 100644 --- a/Documentation/ide/ide.txt +++ b/Documentation/ide/ide.txt @@ -105,7 +105,7 @@ Drives are normally found by auto-probing and/or examining the CMOS/BIOS data. For really weird situations, the apparent (fdisk) geometry can also be specified on the kernel "command line" using LILO. The format of such lines is: - hdx=cyls,heads,sects,wpcom,irq + hdx=cyls,heads,sects or hdx=cdrom where hdx can be any of hda through hdh, Three values are required @@ -214,9 +214,9 @@ driver using the "options=" keyword to insmod, while replacing any ',' with Summary of ide driver parameters for kernel command line -------------------------------------------------------- - "hdx=" is recognized for all "x" from "a" to "h", such as "hdc". + "hdx=" is recognized for all "x" from "a" to "u", such as "hdc". - "idex=" is recognized for all "x" from "0" to "3", such as "ide1". + "idex=" is recognized for all "x" from "0" to "9", such as "ide1". "hdx=noprobe" : drive may be present, but do not probe for it @@ -233,8 +233,6 @@ Summary of ide driver parameters for kernel command line "hdx=remap63" : remap the drive: add 63 to all sector numbers (for DM OnTrack) - "idex=noautotune" : driver will NOT attempt to tune interface speed - "hdx=autotune" : driver will attempt to tune interface speed to the fastest PIO mode supported, if possible for this drive only. @@ -282,10 +280,6 @@ Summary of ide driver parameters for kernel command line "ide=reverse" : formerly called to pci sub-system, but now local. -The following are valid ONLY on ide0, which usually corresponds -to the first ATA interface found on the particular host, and the defaults for -the base,ctl ports must not be altered. - "ide=doubler" : probe/support IDE doublers on Amiga There may be more options than shown -- use the source, Luke!