From: Chris Pascoe Date: Thu, 10 Aug 2006 06:17:16 +0000 (-0300) Subject: V4L/DVB (4495): Fix "no data from ZL10353 based USB tuner" problem X-Git-Tag: v2.6.19-rc1~643^2~80 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=8fb957841b2f4311e6418dcbef24564e4cebb87d;p=linux-2.6-omap-h63xx.git V4L/DVB (4495): Fix "no data from ZL10353 based USB tuner" problem Force parallel transport stream output on the ZL10353 attached to a bluebird device. Addresses the problem where a frontend lock was observed, but no MPEG transport data was received. Signed-off-by: Chris Pascoe Signed-off-by: Mauro Carvalho Chehab --- diff --git a/drivers/media/dvb/dvb-usb/cxusb.c b/drivers/media/dvb/dvb-usb/cxusb.c index ac72e7ed9fc..c710c0176e0 100644 --- a/drivers/media/dvb/dvb-usb/cxusb.c +++ b/drivers/media/dvb/dvb-usb/cxusb.c @@ -349,6 +349,7 @@ static struct mt352_config cxusb_dee1601_config = { static struct zl10353_config cxusb_zl10353_dee1601_config = { .demod_address = 0x0f, + .parallel_ts = 1, }; static struct mt352_config cxusb_mt352_config = { diff --git a/drivers/media/dvb/frontends/zl10353.c b/drivers/media/dvb/frontends/zl10353.c index 953fb55d87b..84abbaf362f 100644 --- a/drivers/media/dvb/frontends/zl10353.c +++ b/drivers/media/dvb/frontends/zl10353.c @@ -243,9 +243,12 @@ static int zl10353_init(struct dvb_frontend *fe) if (debug_regs) zl10353_dump_regs(fe); + if (state->config.parallel_ts) + zl10353_reset_attach[2] &= ~0x20; /* Do a "hard" reset if not already done */ - if (zl10353_read_register(state, 0x50) != 0x03) { + if (zl10353_read_register(state, 0x50) != zl10353_reset_attach[1] || + zl10353_read_register(state, 0x51) != zl10353_reset_attach[2]) { rc = zl10353_write(fe, zl10353_reset_attach, sizeof(zl10353_reset_attach)); if (debug_regs) diff --git a/drivers/media/dvb/frontends/zl10353.h b/drivers/media/dvb/frontends/zl10353.h index 6aec655d881..79a947215c4 100644 --- a/drivers/media/dvb/frontends/zl10353.h +++ b/drivers/media/dvb/frontends/zl10353.h @@ -31,6 +31,9 @@ struct zl10353_config /* set if no pll is connected to the secondary i2c bus */ int no_tuner; + + /* set if parallel ts output is required */ + int parallel_ts; }; #if defined(CONFIG_DVB_ZL10353) || defined(CONFIG_DVB_ZL10353_MODULE)