From: David Brownell Date: Mon, 27 Oct 2008 21:11:34 +0000 (-0700) Subject: at91_ether: request/free GPIO for PHY interrupt X-Git-Tag: v2.6.28-rc3~3^2~12^2~2 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=71527ef484426f2a4fb868da379b46f4408e80d6;p=linux-2.6-omap-h63xx.git at91_ether: request/free GPIO for PHY interrupt When the at91_ether driver is using a GPIO for its PHY interrupt, be sure to request (and later, if needed, free) that GPIO. Signed-off-by: David Brownell Signed-off-by: Jeff Garzik --- diff --git a/drivers/net/arm/at91_ether.c b/drivers/net/arm/at91_ether.c index 0fa53464efb..6f431a887e7 100644 --- a/drivers/net/arm/at91_ether.c +++ b/drivers/net/arm/at91_ether.c @@ -1080,7 +1080,8 @@ static int __init at91ether_setup(unsigned long phy_type, unsigned short phy_add init_timer(&lp->check_timer); lp->check_timer.data = (unsigned long)dev; lp->check_timer.function = at91ether_check_link; - } + } else if (lp->board_data.phy_irq_pin >= 32) + gpio_request(lp->board_data.phy_irq_pin, "ethernet_phy"); /* Display ethernet banner */ printk(KERN_INFO "%s: AT91 ethernet at 0x%08x int=%d %s%s (%s)\n", @@ -1167,6 +1168,9 @@ static int __devexit at91ether_remove(struct platform_device *pdev) struct net_device *dev = platform_get_drvdata(pdev); struct at91_private *lp = netdev_priv(dev); + if (lp->board_data.phy_irq_pin >= 32) + gpio_free(lp->board_data.phy_irq_pin); + unregister_netdev(dev); free_irq(dev->irq, dev); dma_free_coherent(NULL, sizeof(struct recv_desc_bufs), lp->dlist, (dma_addr_t)lp->dlist_phys);