From: Alan Stern Date: Wed, 12 Nov 2008 22:04:53 +0000 (-0500) Subject: USB: EHCI: fix handling of dead controllers X-Git-Tag: v2.6.28-rc5~16^2~3 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=67b2e029743a52670d77864723b4d0d40f7733b5;p=linux-2.6-omap-h63xx.git USB: EHCI: fix handling of dead controllers This patch (as1165) makes a few small changes in the logic used by ehci-hcd when it encounters a controller error: Instead of printing out the masked status, it prints the original status as read directly from the hardware. It doesn't check for the STS_HALT status bit before taking action. The mere fact that the STS_FATAL bit is set means that something bad has happened and the controller needs to be reset. With the old code this test could never succeed because the STS_HALT bit was masked out from the status. I anticipate that this will prevent the occasional "irq X: nobody cared" problem people encounter when their EHCI controllers die. Signed-off-by: Alan Stern Cc: David Brownell Cc: stable Signed-off-by: Greg Kroah-Hartman --- diff --git a/drivers/usb/host/ehci-hcd.c b/drivers/usb/host/ehci-hcd.c index 15a803b206b..4725d15d096 100644 --- a/drivers/usb/host/ehci-hcd.c +++ b/drivers/usb/host/ehci-hcd.c @@ -643,7 +643,7 @@ static int ehci_run (struct usb_hcd *hcd) static irqreturn_t ehci_irq (struct usb_hcd *hcd) { struct ehci_hcd *ehci = hcd_to_ehci (hcd); - u32 status, pcd_status = 0, cmd; + u32 status, masked_status, pcd_status = 0, cmd; int bh; spin_lock (&ehci->lock); @@ -656,14 +656,14 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd) goto dead; } - status &= INTR_MASK; - if (!status) { /* irq sharing? */ + masked_status = status & INTR_MASK; + if (!masked_status) { /* irq sharing? */ spin_unlock(&ehci->lock); return IRQ_NONE; } /* clear (just) interrupts */ - ehci_writel(ehci, status, &ehci->regs->status); + ehci_writel(ehci, masked_status, &ehci->regs->status); cmd = ehci_readl(ehci, &ehci->regs->command); bh = 0; @@ -734,18 +734,17 @@ static irqreturn_t ehci_irq (struct usb_hcd *hcd) /* PCI errors [4.15.2.4] */ if (unlikely ((status & STS_FATAL) != 0)) { + ehci_err(ehci, "fatal error\n"); dbg_cmd(ehci, "fatal", cmd); dbg_status(ehci, "fatal", status); - if (status & STS_HALT) { - ehci_err (ehci, "fatal error\n"); + ehci_halt(ehci); dead: - ehci_reset (ehci); - ehci_writel(ehci, 0, &ehci->regs->configured_flag); - /* generic layer kills/unlinks all urbs, then - * uses ehci_stop to clean up the rest - */ - bh = 1; - } + ehci_reset(ehci); + ehci_writel(ehci, 0, &ehci->regs->configured_flag); + /* generic layer kills/unlinks all urbs, then + * uses ehci_stop to clean up the rest + */ + bh = 1; } if (bh)