From: Andrew Vasquez Date: Thu, 14 Aug 2008 04:36:56 +0000 (-0700) Subject: [SCSI] qla2xxx: Correct synchronization of software/firmware fcport states. X-Git-Tag: v2.6.27-rc4~33^2~14 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=6390d1f33faecf48e31f27dd7dbe928540f8acfc;p=linux-2.6-omap-h63xx.git [SCSI] qla2xxx: Correct synchronization of software/firmware fcport states. Greg Wettstein (greg@enjellic.com) noted: http://article.gmane.org/gmane.linux.scsi/43409 on a reboot of a previously recognized SCST target, the initiator driver would be unable to re-recognize the device as a target. It turns out that prior to the SCST software reloading and returning it's "target-capable" abilities in the PRLI payload, the HBA would be re-initialized as an initiator-only type port. Since initiators typically classify themselves as an FCP-2 capable device, both software and firmware do not perform an explicit logout during port-loss. Unfortunately, as can be seen by the failure case, when the port (now target-capable) returns, firmware performs an ADISC without a follow-on PRLI, leaving stale 'initiator-only' data in the firmware's port database. Correct the discrepancy by performing the explicit logout during the transport's request to terminate-rport-io, thus synchronizing port states and ensuring a follow-on PRLI is performed. Reported-by: Greg Wettstein Signed-off-by: Andrew Vasquez Cc: Stable Tree Signed-off-by: James Bottomley --- diff --git a/drivers/scsi/qla2xxx/qla_attr.c b/drivers/scsi/qla2xxx/qla_attr.c index a319a20ed44..45e7dcb4b34 100644 --- a/drivers/scsi/qla2xxx/qla_attr.c +++ b/drivers/scsi/qla2xxx/qla_attr.c @@ -993,6 +993,17 @@ qla2x00_terminate_rport_io(struct fc_rport *rport) { fc_port_t *fcport = *(fc_port_t **)rport->dd_data; + /* + * At this point all fcport's software-states are cleared. Perform any + * final cleanup of firmware resources (PCBs and XCBs). + */ + if (fcport->loop_id != FC_NO_LOOP_ID) { + fcport->ha->isp_ops->fabric_logout(fcport->ha, fcport->loop_id, + fcport->d_id.b.domain, fcport->d_id.b.area, + fcport->d_id.b.al_pa); + fcport->loop_id = FC_NO_LOOP_ID; + } + qla2x00_abort_fcport_cmds(fcport); scsi_target_unblock(&rport->dev); }