From: Michael Chan <mchan@broadcom.com>
Date: Fri, 2 May 2008 23:56:44 +0000 (-0700)
Subject: bnx2: Fix remote PHY initial link state.
X-Git-Tag: v2.6.26-rc1~5^2~7
X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=543a827d7a5600a71855bd6afacac78536c86822;p=linux-2.6-omap-h63xx.git

bnx2: Fix remote PHY initial link state.

On some remote PHY blade systems, the driver receives no initial link
interrupt.  As a result, the GMII/MII MAC mode does not get setup properly.
To fix this problem, we add an initial poll of the link state after chip
reset.

With this change, the setting of the initial carrier state in the init
code can be eliminated.

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: Benjamin Li <benli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
---

diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 506c5ccd715..d681f3153e7 100644
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -4216,13 +4216,6 @@ bnx2_init_remote_phy(struct bnx2 *bp)
 		if (netif_running(bp->dev)) {
 			u32 sig;
 
-			if (val & BNX2_LINK_STATUS_LINK_UP) {
-				bp->link_up = 1;
-				netif_carrier_on(bp->dev);
-			} else {
-				bp->link_up = 0;
-				netif_carrier_off(bp->dev);
-			}
 			sig = BNX2_DRV_ACK_CAP_SIGNATURE |
 			      BNX2_FW_CAP_REMOTE_PHY_CAPABLE;
 			bnx2_shmem_wr(bp, BNX2_DRV_ACK_CAP_MB, sig);
@@ -4879,6 +4872,8 @@ bnx2_init_nic(struct bnx2 *bp)
 	spin_lock_bh(&bp->phy_lock);
 	bnx2_init_phy(bp);
 	bnx2_set_link(bp);
+	if (bp->phy_flags & BNX2_PHY_FLAG_REMOTE_PHY_CAP)
+		bnx2_remote_phy_event(bp);
 	spin_unlock_bh(&bp->phy_lock);
 	return 0;
 }