From: Steve Glendinning Date: Thu, 19 Mar 2009 06:37:18 +0000 (-0700) Subject: smsc911x: reset last known duplex and carrier on open X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=44c1d6f99d4c86638bffabf0b7a232d0fe7ae574;p=linux-2.6-omap-h63xx.git smsc911x: reset last known duplex and carrier on open smsc911x_phy_adjust_link is called periodically by the phy layer (as it's run in polling mode), and it only updates the hardware when it sees a change in duplex or carrier. This patch clears the last known values every time the interface is brought up, instead of only when the module is loaded. Without this patch the adjust_link function never updates the hardware after an ifconfig down; ifconfig up. On a full duplex link this causes the tx error counter to increment, even though packets are correctly transmitted, as the default MAC_CR register setting is for half duplex. The tx errors are "no carrier" errors, which should be ignored in full-duplex mode. When MAC_CR is set to "full duplex" mode they are correctly ignored by the hardware. Note that even with this patch the tx error counter can increment if packets are transmitted between "ifconfig up" and the first phy poll interval. An improved solution would use the phy interrupt with phylib, but I haven't managed to make this work 100% robustly yet. Signed-off-by: Steve Glendinning Signed-off-by: David S. Miller --- diff --git a/drivers/net/smsc911x.c b/drivers/net/smsc911x.c index 9a78daec2fe..d1590ac55e4 100644 --- a/drivers/net/smsc911x.c +++ b/drivers/net/smsc911x.c @@ -1225,6 +1225,10 @@ static int smsc911x_open(struct net_device *dev) dev_info(&dev->dev, "SMSC911x/921x identified at %#08lx, IRQ: %d\n", (unsigned long)pdata->ioaddr, dev->irq); + /* Reset the last known duplex and carrier */ + pdata->last_duplex = -1; + pdata->last_carrier = -1; + /* Bring the PHY up */ phy_start(pdata->phy_dev);