From: Stephen Hemminger Date: Thu, 8 Jan 2009 02:00:55 +0000 (-0800) Subject: xircom: convert devices to new API X-Git-Tag: v2.6.29-rc1~45^2~39 X-Git-Url: http://pilppa.com/gitweb/?a=commitdiff_plain;h=1034c9f69ae7b61d408836e60c6a2b5afc6e48bc;p=linux-2.6-omap-h63xx.git xircom: convert devices to new API Convert to net_device_ops and internal net_device_stats Signed-off-by: Stephen Hemminger Signed-off-by: David S. Miller --- diff --git a/drivers/net/tulip/xircom_cb.c b/drivers/net/tulip/xircom_cb.c index 13c8703ecb9..c2ca9f40e40 100644 --- a/drivers/net/tulip/xircom_cb.c +++ b/drivers/net/tulip/xircom_cb.c @@ -104,10 +104,8 @@ struct xircom_private { */ spinlock_t lock; - struct pci_dev *pdev; struct net_device *dev; - struct net_device_stats stats; }; @@ -119,7 +117,6 @@ static int xircom_start_xmit(struct sk_buff *skb, struct net_device *dev); static int xircom_open(struct net_device *dev); static int xircom_close(struct net_device *dev); static void xircom_up(struct xircom_private *card); -static struct net_device_stats *xircom_get_stats(struct net_device *dev); #ifdef CONFIG_NET_POLL_CONTROLLER static void xircom_poll_controller(struct net_device *dev); #endif @@ -194,6 +191,18 @@ static const struct ethtool_ops netdev_ethtool_ops = { .get_drvinfo = netdev_get_drvinfo, }; +static const struct net_device_ops netdev_ops = { + .ndo_open = xircom_open, + .ndo_stop = xircom_close, + .ndo_start_xmit = xircom_start_xmit, + .ndo_change_mtu = eth_change_mtu, + .ndo_set_mac_address = eth_mac_addr, + .ndo_validate_addr = eth_validate_addr, +#ifdef CONFIG_NET_POLL_CONTROLLER + .ndo_poll_controller = xircom_poll_controller, +#endif +}; + /* xircom_probe is the code that gets called on device insertion. it sets up the hardware and registers the device to the networklayer. @@ -266,13 +275,7 @@ static int __devinit xircom_probe(struct pci_dev *pdev, const struct pci_device_ read_mac_address(private); setup_descriptors(private); - dev->open = &xircom_open; - dev->hard_start_xmit = &xircom_start_xmit; - dev->stop = &xircom_close; - dev->get_stats = &xircom_get_stats; -#ifdef CONFIG_NET_POLL_CONTROLLER - dev->poll_controller = &xircom_poll_controller; -#endif + dev->netdev_ops = &netdev_ops; SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops); pci_set_drvdata(pdev, dev); @@ -497,14 +500,6 @@ static int xircom_close(struct net_device *dev) } - -static struct net_device_stats *xircom_get_stats(struct net_device *dev) -{ - struct xircom_private *card = netdev_priv(dev); - return &card->stats; -} - - #ifdef CONFIG_NET_POLL_CONTROLLER static void xircom_poll_controller(struct net_device *dev) { @@ -1193,7 +1188,7 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri skb = dev_alloc_skb(pkt_len + 2); if (skb == NULL) { - card->stats.rx_dropped++; + dev->stats.rx_dropped++; goto out; } skb_reserve(skb, 2); @@ -1201,8 +1196,8 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri skb_put(skb, pkt_len); skb->protocol = eth_type_trans(skb, dev); netif_rx(skb); - card->stats.rx_packets++; - card->stats.rx_bytes += pkt_len; + dev->stats.rx_packets++; + dev->stats.rx_bytes += pkt_len; out: /* give the buffer back to the card */ @@ -1232,16 +1227,16 @@ static void investigate_write_descriptor(struct net_device *dev, struct xircom_p #endif if (status > 0) { /* bit 31 is 0 when done */ if (card->tx_skb[descnr]!=NULL) { - card->stats.tx_bytes += card->tx_skb[descnr]->len; + dev->stats.tx_bytes += card->tx_skb[descnr]->len; dev_kfree_skb_irq(card->tx_skb[descnr]); } card->tx_skb[descnr] = NULL; /* Bit 8 in the status field is 1 if there was a collision */ if (status&(1<<8)) - card->stats.collisions++; + dev->stats.collisions++; card->tx_buffer[4*descnr] = 0; /* descriptor is free again */ netif_wake_queue (dev); - card->stats.tx_packets++; + dev->stats.tx_packets++; } leave("investigate_write_descriptor");