[SKY2]: fix power settings on Yukon XL

Make sure PCI register for PHY power gets set correctly.

Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 4832f64037214b2b8f60808839e0d0c71df4bd76..c9ee8a2c24b564e049429f366f13f995550778d4 100644 (file)
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -606,20 +606,19 @@ static void sky2_phy_power(struct sky2_hw *hw, unsigned port, int onoff)
 {
        struct pci_dev *pdev = hw->pdev;
        u32 reg1;
-       static const u32 phy_power[]
-               = { PCI_Y2_PHY1_POWD, PCI_Y2_PHY2_POWD };
-
-       /* looks like this XL is back asswards .. */
-       if (hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1)
-               onoff = !onoff;
+       static const u32 phy_power[] = { PCI_Y2_PHY1_POWD, PCI_Y2_PHY2_POWD };
+       static const u32 coma_mode[] = { PCI_Y2_PHY1_COMA, PCI_Y2_PHY2_COMA };
 
        pci_read_config_dword(pdev, PCI_DEV_REG1, &reg1);
+       /* Turn on/off phy power saving */
        if (onoff)
-               /* Turn off phy power saving */
                reg1 &= ~phy_power[port];
        else
                reg1 |= phy_power[port];
 
+       if (onoff && hw->chip_id == CHIP_ID_YUKON_XL && hw->chip_rev > 1)
+               reg1 |= coma_mode[port];
+
        pci_write_config_dword(pdev, PCI_DEV_REG1, reg1);
        pci_read_config_dword(pdev, PCI_DEV_REG1, &reg1);