[SCSI] qla2xxx: Correct issue where incorrect init-fw mailbox command was used on...

BIT_2 of the firmware attributes is only valid on FW-interface-2
type HBAs.  Code in commit
c48339decceec8e011498b0fc4c7c7d8b2ea06c1 would cause the
incorrect initialize-firmware mailbox command to be issued for
non-NPIV capable ISPs.  Correct this by reverting to previously
used (and correct) pre-condition 'if' check.

Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

diff --git a/drivers/scsi/qla2xxx/qla_mbx.c b/drivers/scsi/qla2xxx/qla_mbx.c
index 0c10c0b0fb732602e5f0548be2e7be23a3ad1615..99d29fff836d631bc37686b6c45bee7972dcb4e4 100644 (file)
--- a/drivers/scsi/qla2xxx/qla_mbx.c
+++ b/drivers/scsi/qla2xxx/qla_mbx.c
@@ -980,7 +980,7 @@ qla2x00_init_firmware(scsi_qla_host_t *ha, uint16_t size)
        DEBUG11(printk("qla2x00_init_firmware(%ld): entered.\n",
            ha->host_no));
 
-       if (ha->fw_attributes & BIT_2)
+       if (ha->flags.npiv_supported)
                mcp->mb[0] = MBC_MID_INITIALIZE_FIRMWARE;
        else
                mcp->mb[0] = MBC_INITIALIZE_FIRMWARE;