[PATCH] s390: qeth :allow setting of attribute "route6" to "no_router".

[patch 4/6] s390: qeth :allow setting of attribute "route6" to "no_router".

From: Ursula Braun <braunu@de.ibm.com>
	when setting route6 attribute back to no_router qeth does not
	issue an IP ASSIST command to reset router value to no_router.
	Once primary_router is set device stays in this mode.
	Issue an IP ASSIST command when no_router is set in route6.
	Device will be reset and thus will not longer run as a primary
	router.

Signed-off-by: Frank Pavlic <fpavlic@de.ibm.com>
diffstat:
 qeth_main.c |    5 -----
 1 files changed, 5 deletions(-)
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/s390/net/qeth_main.c b/drivers/s390/net/qeth_main.c
index 69329ea61e2bf4ac749a8a9e0b5cc9c60b99b284..021cd5d08c61071a648d20929bf84c10037efc4c 100644 (file)
--- a/drivers/s390/net/qeth_main.c
+++ b/drivers/s390/net/qeth_main.c
@@ -7339,11 +7339,6 @@ qeth_setrouting_v6(struct qeth_card *card)
        qeth_correct_routing_type(card, &card->options.route6.type,
                                  QETH_PROT_IPV6);
 
-       if ((card->options.route6.type == NO_ROUTER) ||
-           ((card->info.type == QETH_CARD_TYPE_OSAE) &&
-            (card->options.route6.type == MULTICAST_ROUTER) &&
-            !qeth_is_supported6(card,IPA_OSA_MC_ROUTER)))
-               return 0;
        rc = qeth_send_setrouting(card, card->options.route6.type,
                                  QETH_PROT_IPV6);
        if (rc) {