ide: remove dead <asm-arm/arch-sa1100/ide.h>

It has been dead for more than 3 years and needs to be converted
to use platform PATA support anyway.

Cc: Russell King <rmk@arm.linux.org.uk>
Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>

diff --git a/arch/arm/mach-sa1100/include/mach/ide.h b/arch/arm/mach-sa1100/include/mach/ide.h
deleted file mode 100644 (file)
index 4c99c8f..0000000
--- a/arch/arm/mach-sa1100/include/mach/ide.h
+++ /dev/null
@@ -1,75 +0,0 @@
-/*
- * arch/arm/mach-sa1100/include/mach/ide.h
- *
- * Copyright (c) 1998 Hugo Fiennes & Nicolas Pitre
- *
- * 18-aug-2000: Cleanup by Erik Mouw (J.A.K.Mouw@its.tudelft.nl)
- *              Get rid of the special ide_init_hwif_ports() functions
- *              and make a generalised function that can be used by all
- *              architectures.
- */
-
-#include <asm/irq.h>
-#include <mach/hardware.h>
-#include <asm/mach-types.h>
-
-#error "This code is broken and needs update to match with current ide support"
-
-
-/*
- * Set up a hw structure for a specified data port, control port and IRQ.
- * This should follow whatever the default interface uses.
- */
-static inline void ide_init_hwif_ports(hw_regs_t *hw, unsigned long data_port,
-                                      unsigned long ctrl_port, int *irq)
-{
-       unsigned long reg = data_port;
-       int i;
-       int regincr = 1;
-
-       /* The Empeg board has the first two address lines unused */
-       if (machine_is_empeg())
-               regincr = 1 << 2;
-
-       /* The LART doesn't use A0 for IDE */
-       if (machine_is_lart())
-               regincr = 1 << 1;
-
-       memset(hw, 0, sizeof(*hw));
-
-       for (i = 0; i <= 7; i++) {
-               hw->io_ports_array[i] = reg;
-               reg += regincr;
-       }
-
-       hw->io_ports.ctl_addr = ctrl_port;
-
-       if (irq)
-               *irq = 0;
-}
-
-/*
- * This registers the standard ports for this architecture with the IDE
- * driver.
- */
-static __inline__ void
-ide_init_default_hwifs(void)
-{
-    if (machine_is_lart()) {
-#ifdef CONFIG_SA1100_LART
-        hw_regs_t hw;
-
-        /* Enable GPIO as interrupt line */
-        GPDR &= ~LART_GPIO_IDE;
-       set_irq_type(LART_IRQ_IDE, IRQ_TYPE_EDGE_RISING);
-
-        /* set PCMCIA interface timing */
-        MECR = 0x00060006;
-
-        /* init the interface */
-       ide_init_hwif_ports(&hw, PCMCIA_IO_0_BASE + 0x0000, PCMCIA_IO_0_BASE + 0x1000, NULL);
-        hw.irq = LART_IRQ_IDE;
-        ide_register_hw(&hw);
-#endif
-    }
-}