]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
[PATCH] CCISS: disable device when returning failure
authorBjorn Helgaas <bjorn.helgaas@hp.com>
Sun, 25 Jun 2006 12:49:01 +0000 (05:49 -0700)
committerLinus Torvalds <torvalds@g5.osdl.org>
Sun, 25 Jun 2006 17:01:21 +0000 (10:01 -0700)
If something fails after we call pci_enable_device(), we should call
pci_disable_device() before returning the failure.

Signed-off-by: Bjorn Helgaas <bjorn.helgaas@hp.com>
Acked-by: Jeff Garzik <jeff@garzik.org>
Acked-by: Mike Miller <mike.miller@hp.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
drivers/block/cciss.c

index e2df9eb6b90debfde827a4deff362f4cb89a290f..83bd091fc6ce9978853276b4fc285b6da735c80c 100644 (file)
@@ -2744,7 +2744,7 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
        __u64 cfg_offset;
        __u32 cfg_base_addr;
        __u64 cfg_base_addr_index;
-       int i;
+       int i, err;
 
        /* check to see if controller has been disabled */
        /* BEFORE trying to enable it */
@@ -2752,13 +2752,14 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
        if(!(command & 0x02))
        {
                printk(KERN_WARNING "cciss: controller appears to be disabled\n");
-               return(-1);
+               return -ENODEV;
        }
 
-       if (pci_enable_device(pdev))
+       err = pci_enable_device(pdev);
+       if (err)
        {
                printk(KERN_ERR "cciss: Unable to Enable PCI device\n");
-               return( -1);
+               return err;
        }
 
        subsystem_vendor_id = pdev->subsystem_vendor;
@@ -2824,7 +2825,8 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
        }
        if (scratchpad != CCISS_FIRMWARE_READY) {
                printk(KERN_WARNING "cciss: Board not ready.  Timed out.\n");
-               return -1;
+               err = -ENODEV;
+               goto err_out_disable_pdev;
        }
 
        /* get the address index number */
@@ -2841,7 +2843,8 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
        if (cfg_base_addr_index == -1) {
                printk(KERN_WARNING "cciss: Cannot find cfg_base_addr_index\n");
                release_io_mem(c);
-               return -1;
+               err = -ENODEV;
+               goto err_out_disable_pdev;
        }
 
        cfg_offset = readl(c->vaddr + SA5_CTMEM_OFFSET);
@@ -2868,7 +2871,8 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
                printk(KERN_WARNING "cciss: Sorry, I don't know how"
                        " to access the Smart Array controller %08lx\n", 
                                (unsigned long)board_id);
-               return -1;
+               err = -ENODEV;
+               goto err_out_disable_pdev;
        }
        if (  (readb(&c->cfgtable->Signature[0]) != 'C') ||
              (readb(&c->cfgtable->Signature[1]) != 'I') ||
@@ -2876,7 +2880,8 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
              (readb(&c->cfgtable->Signature[3]) != 'S') )
        {
                printk("Does not appear to be a valid CISS config table\n");
-               return -1;
+               err = -ENODEV;
+               goto err_out_disable_pdev;
        }
 
 #ifdef CONFIG_X86
@@ -2920,10 +2925,14 @@ static int cciss_pci_init(ctlr_info_t *c, struct pci_dev *pdev)
        {
                printk(KERN_WARNING "cciss: unable to get board into"
                                        " simple mode\n");
-               return -1;
+               err = -ENODEV;
+               goto err_out_disable_pdev;
        }
        return 0;
 
+err_out_disable_pdev:
+       pci_disable_device(pdev);
+       return err;
 }
 
 /*