select GENERIC_TIME
select GENERIC_CLOCKEVENTS
select TICK_ONESHOT
+ select PLAT_PXA
help
Support for Intel/Marvell's PXA2xx/PXA3xx processor line.
source "arch/arm/mach-mv78xx0/Kconfig"
source "arch/arm/mach-pxa/Kconfig"
+source "arch/arm/plat-pxa/Kconfig"
source "arch/arm/mach-sa1100/Kconfig"
config PLAT_ORION
bool
+config PLAT_PXA
+ bool
+
source arch/arm/mm/Kconfig
config IWMMXT
textofs-$(CONFIG_SA1111) := 0x00208000
endif
machine-$(CONFIG_ARCH_PXA) := pxa
+ plat-$(CONFIG_PLAT_PXA) := pxa
machine-$(CONFIG_ARCH_L7200) := l7200
machine-$(CONFIG_ARCH_INTEGRATOR) := integrator
textofs-$(CONFIG_ARCH_CLPS711X) := 0x00028000
#
# Common support (must be linked before board specific support)
-obj-y += clock.o devices.o generic.o irq.o dma.o \
+obj-y += clock.o devices.o generic.o irq.o \
time.o gpio.o reset.o
obj-$(CONFIG_PM) += pm.o sleep.o standby.o
/* DMA Controller Registers Definitions */
#define DMAC_REGS_VIRT io_p2v(0x40000000)
-#define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x))))
-
-#define DCSR(n) DMAC_REG((n) << 2)
-#define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */
-#define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */
-#define DDADR(n) DMAC_REG(0x0200 + ((n) << 4))
-#define DSADR(n) DMAC_REG(0x0204 + ((n) << 4))
-#define DTADR(n) DMAC_REG(0x0208 + ((n) << 4))
-#define DCMD(n) DMAC_REG(0x020c + ((n) << 4))
-#define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \
- (((n) & 0x3f) << 2))
-
-#define DCSR_RUN (1 << 31) /* Run Bit (read / write) */
-#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */
-#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */
-#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
-#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
-#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
-#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
-#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
-
-#if defined(CONFIG_PXA27x) || defined(CONFIG_PXA3xx)
-#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */
-#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
-#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
-#define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */
-#define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */
-#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
-#define DCSR_EORINTR (1 << 9) /* The end of Receive */
-#endif
-
-#define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */
-#define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */
-
-#define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */
-#define DDADR_STOP (1 << 0) /* Stop (read / write) */
-
-#define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */
-#define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */
-#define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */
-#define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */
-#define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */
-#define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */
-#define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */
-#define DCMD_BURST8 (1 << 16) /* 8 byte burst */
-#define DCMD_BURST16 (2 << 16) /* 16 byte burst */
-#define DCMD_BURST32 (3 << 16) /* 32 byte burst */
-#define DCMD_WIDTH1 (1 << 14) /* 1 byte width */
-#define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */
-#define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */
-#define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */
-
-/*
- * Descriptor structure for PXA's DMA engine
- * Note: this structure must always be aligned to a 16-byte boundary.
- */
-
-typedef struct pxa_dma_desc {
- volatile u32 ddadr; /* Points to the next descriptor + flags */
- volatile u32 dsadr; /* DSADR value for the current transfer */
- volatile u32 dtadr; /* DTADR value for the current transfer */
- volatile u32 dcmd; /* DCMD value for the current transfer */
-} pxa_dma_desc;
-
-typedef enum {
- DMA_PRIO_HIGH = 0,
- DMA_PRIO_MEDIUM = 1,
- DMA_PRIO_LOW = 2
-} pxa_dma_prio;
-
-/*
- * DMA registration
- */
-
-int __init pxa_init_dma(int irq, int num_ch);
-
-int pxa_request_dma (char *name,
- pxa_dma_prio prio,
- void (*irq_handler)(int, void *),
- void *data);
-
-void pxa_free_dma (int dma_ch);
+#include <plat/dma.h>
#endif /* _ASM_ARCH_DMA_H */
--- /dev/null
+if PLAT_PXA
+
+endif
--- /dev/null
+#
+# Makefile for code common across different PXA processor families
+#
+
+obj-y := dma.o
+
/*
- * linux/arch/arm/mach-pxa/dma.c
+ * linux/arch/arm/plat-pxa/dma.c
*
* PXA DMA registration and IRQ dispatching
*
static int num_dma_channels;
int pxa_request_dma (char *name, pxa_dma_prio prio,
- void (*irq_handler)(int, void *),
- void *data)
+ void (*irq_handler)(int, void *),
+ void *data)
{
unsigned long flags;
int i, found = 0;
--- /dev/null
+#ifndef __PLAT_DMA_H
+#define __PLAT_DMA_H
+
+#define DMAC_REG(x) (*((volatile u32 *)(DMAC_REGS_VIRT + (x))))
+
+#define DCSR(n) DMAC_REG((n) << 2)
+#define DALGN DMAC_REG(0x00a0) /* DMA Alignment Register */
+#define DINT DMAC_REG(0x00f0) /* DMA Interrupt Register */
+#define DDADR(n) DMAC_REG(0x0200 + ((n) << 4))
+#define DSADR(n) DMAC_REG(0x0204 + ((n) << 4))
+#define DTADR(n) DMAC_REG(0x0208 + ((n) << 4))
+#define DCMD(n) DMAC_REG(0x020c + ((n) << 4))
+#define DRCMR(n) DMAC_REG((((n) < 64) ? 0x0100 : 0x1100) + \
+ (((n) & 0x3f) << 2))
+
+#define DCSR_RUN (1 << 31) /* Run Bit (read / write) */
+#define DCSR_NODESC (1 << 30) /* No-Descriptor Fetch (read / write) */
+#define DCSR_STOPIRQEN (1 << 29) /* Stop Interrupt Enable (read / write) */
+#define DCSR_REQPEND (1 << 8) /* Request Pending (read-only) */
+#define DCSR_STOPSTATE (1 << 3) /* Stop State (read-only) */
+#define DCSR_ENDINTR (1 << 2) /* End Interrupt (read / write) */
+#define DCSR_STARTINTR (1 << 1) /* Start Interrupt (read / write) */
+#define DCSR_BUSERR (1 << 0) /* Bus Error Interrupt (read / write) */
+
+#define DCSR_EORIRQEN (1 << 28) /* End of Receive Interrupt Enable (R/W) */
+#define DCSR_EORJMPEN (1 << 27) /* Jump to next descriptor on EOR */
+#define DCSR_EORSTOPEN (1 << 26) /* STOP on an EOR */
+#define DCSR_SETCMPST (1 << 25) /* Set Descriptor Compare Status */
+#define DCSR_CLRCMPST (1 << 24) /* Clear Descriptor Compare Status */
+#define DCSR_CMPST (1 << 10) /* The Descriptor Compare Status */
+#define DCSR_EORINTR (1 << 9) /* The end of Receive */
+
+#define DRCMR_MAPVLD (1 << 7) /* Map Valid (read / write) */
+#define DRCMR_CHLNUM 0x1f /* mask for Channel Number (read / write) */
+
+#define DDADR_DESCADDR 0xfffffff0 /* Address of next descriptor (mask) */
+#define DDADR_STOP (1 << 0) /* Stop (read / write) */
+
+#define DCMD_INCSRCADDR (1 << 31) /* Source Address Increment Setting. */
+#define DCMD_INCTRGADDR (1 << 30) /* Target Address Increment Setting. */
+#define DCMD_FLOWSRC (1 << 29) /* Flow Control by the source. */
+#define DCMD_FLOWTRG (1 << 28) /* Flow Control by the target. */
+#define DCMD_STARTIRQEN (1 << 22) /* Start Interrupt Enable */
+#define DCMD_ENDIRQEN (1 << 21) /* End Interrupt Enable */
+#define DCMD_ENDIAN (1 << 18) /* Device Endian-ness. */
+#define DCMD_BURST8 (1 << 16) /* 8 byte burst */
+#define DCMD_BURST16 (2 << 16) /* 16 byte burst */
+#define DCMD_BURST32 (3 << 16) /* 32 byte burst */
+#define DCMD_WIDTH1 (1 << 14) /* 1 byte width */
+#define DCMD_WIDTH2 (2 << 14) /* 2 byte width (HalfWord) */
+#define DCMD_WIDTH4 (3 << 14) /* 4 byte width (Word) */
+#define DCMD_LENGTH 0x01fff /* length mask (max = 8K - 1) */
+
+/*
+ * Descriptor structure for PXA's DMA engine
+ * Note: this structure must always be aligned to a 16-byte boundary.
+ */
+
+typedef struct pxa_dma_desc {
+ volatile u32 ddadr; /* Points to the next descriptor + flags */
+ volatile u32 dsadr; /* DSADR value for the current transfer */
+ volatile u32 dtadr; /* DTADR value for the current transfer */
+ volatile u32 dcmd; /* DCMD value for the current transfer */
+} pxa_dma_desc;
+
+typedef enum {
+ DMA_PRIO_HIGH = 0,
+ DMA_PRIO_MEDIUM = 1,
+ DMA_PRIO_LOW = 2
+} pxa_dma_prio;
+
+/*
+ * DMA registration
+ */
+
+int __init pxa_init_dma(int irq, int num_ch);
+
+int pxa_request_dma (char *name,
+ pxa_dma_prio prio,
+ void (*irq_handler)(int, void *),
+ void *data);
+
+void pxa_free_dma (int dma_ch);
+
+#endif /* __PLAT_DMA_H */
projects / linux-2.6-omap-h63xx.git / commitdiff