* This can be done through registers.  It is not required since
         * a full chip reset is used.
         */
-       return (0);
+       return 0;
 }
 
 static int my3126_interrupt_enable(struct cphy *cphy)
 {
        schedule_delayed_work(&cphy->phy_update, HZ/30);
        t1_tpi_read(cphy->adapter, A_ELMER0_GPO, &cphy->elmer_gpo);
-       return (0);
+       return 0;
 }
 
 static int my3126_interrupt_disable(struct cphy *cphy)
 {
        cancel_rearming_delayed_work(&cphy->phy_update);
-       return (0);
+       return 0;
 }
 
 static int my3126_interrupt_clear(struct cphy *cphy)
 {
-       return (0);
+       return 0;
 }
 
 #define OFFSET(REG_ADDR)    (REG_ADDR << 2)
 
 static int my3126_set_loopback(struct cphy *cphy, int on)
 {
-       return (0);
+       return 0;
 }
 
 /* To check the activity LED */
        if (fc)
                *fc = PAUSE_RX | PAUSE_TX;
 
-       return (0);
+       return 0;
 }
 
 static void my3126_destroy(struct cphy *cphy)
        INIT_DELAYED_WORK(&cphy->phy_update, my3216_poll);
        cphy->bmsr = 0;
 
-       return (cphy);
+       return cphy;
 }
 
 /* Chip Reset */
        val |= 0x8000;
        t1_tpi_write(adapter, A_ELMER0_GPO, val);
        udelay(100);
-       return (0);
+       return 0;
 }
 
 struct gphy t1_my3126_ops = {
 
        else if((result & (1<<8)) != 0x0)
                CH_ERR("bist read error: 0x%x\n", result);
 
-       return(result & 0xff);
+       return (result & 0xff);
 }
 
 static int bist_wr(adapter_t *adapter, int moduleid, int address, int value)
        else if((result & (1<<26)) != 0x0)
                CH_ERR("bist write error: 0x%x\n", result);
 
-       return(0);
+       return 0;
 }
 
 static int run_bist(adapter_t *adapter, int moduleid)
        (void) bist_wr(adapter,moduleid, 0x00, 0x02);
        (void) bist_wr(adapter,moduleid, 0x01, 0x01);
 
-       return(0);
+       return 0;
 }
 
 static int check_bist(adapter_t *adapter, int moduleid)
        if ((result & 3) != 0x3)
                CH_ERR("Result: 0x%x  BIST error in ram %d, column: 0x%04x\n",
                        result, moduleid, column);
-       return(0);
+       return 0;
 }
 
 static int enable_mem(adapter_t *adapter, int moduleid)
 {
        /*enable mem*/
        (void) bist_wr(adapter,moduleid, 0x00, 0x00);
-       return(0);
+       return 0;
 }
 
 static int run_bist_all(adapter_t *adapter)
        udelay(300);
        vsc_write(adapter, REG_MEM_BIST, 0x0);
        mdelay(10);
-       return(0);
+       return 0;
 }
 
 static int mac_intr_handler(struct cmac *mac)