e1000: remove e1000_clean_tx_irq call from e1000_netpoll

The call to e1000_clean_tx_irq in e1000_netpoll can race with the call
to e1000_clean_tx_irq in e1000_clean.  With a small bit of tweaking to
to netpoll_send_skb to simulate a system that was under extreme stress,
I was able to reproduce these concurrent calls.  This can result in
multiple frees to the skbs on the tx ring buffer.

Dropping this call from e1000_netpoll should be fine since we can rely
on the calls in e1000_clean to do what is needed since napi will poll
the hardware just after calling poll_controller.

Signed-off-by: Andy Gospodarek <andy@greyhouse.net>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>

diff --git a/drivers/net/e1000/e1000_main.c b/drivers/net/e1000/e1000_main.c
index b0e2493085b0136d96d5fa2ef399b457d5899535..311ca266bd77ac62558f89069797d200acb5d668 100644 (file)
--- a/drivers/net/e1000/e1000_main.c
+++ b/drivers/net/e1000/e1000_main.c
@@ -5251,7 +5251,6 @@ e1000_netpoll(struct net_device *netdev)
 
        disable_irq(adapter->pdev->irq);
        e1000_intr(adapter->pdev->irq, netdev);
-       e1000_clean_tx_irq(adapter, adapter->tx_ring);
 #ifndef CONFIG_E1000_NAPI
        adapter->clean_rx(adapter, adapter->rx_ring);
 #endif