pm: document use of RTC in pm_trace

As pm_trace uses the system's hardware clock to save its magic value,
users of that option should be warned that using this debug option will
result in an incorrect system time after resume.

Signed-off-by: Frans Pop <elendil@planet.nl>
Acked-by: Pavel Machek <pavel@suse.cz>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

diff --git a/Documentation/power/s2ram.txt b/Documentation/power/s2ram.txt
index b05f512130eaa1cb3f75da9414cf65d80cfe5b62..2ebdc6091ce17ff6464aeb4cec35939983045de6 100644 (file)
--- a/Documentation/power/s2ram.txt
+++ b/Documentation/power/s2ram.txt
@@ -54,3 +54,21 @@ used to run with "radeonfb" (it's an ATI Radeon mobility). It turns out
 that "radeonfb" simply cannot resume that device - it tries to set the
 PLL's, and it just _hangs_. Using the regular VGA console and letting X
 resume it instead works fine.
+
+NOTE
+====
+pm_trace uses the system's Real Time Clock (RTC) to save the magic number.
+Reason for this is that the RTC is the only reliably available piece of
+hardware during resume operations where a value can be set that will
+survive a reboot.
+
+Consequence is that after a resume (even if it is successful) your system
+clock will have a value corresponding to the magic mumber instead of the
+correct date/time! It is therefore advisable to use a program like ntp-date
+or rdate to reset the correct date/time from an external time source when
+using this trace option.
+
+As the clock keeps ticking it is also essential that the reboot is done
+quickly after the resume failure. The trace option does not use the seconds
+or the low order bits of the minutes of the RTC, but a too long delay will
+corrupt the magic value.