]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
USB: ehci: qh/qtd cleanup comments
authorDavid Brownell <david-b@pacbell.net>
Thu, 10 Apr 2008 21:21:06 +0000 (14:21 -0700)
committerGreg Kroah-Hartman <gregkh@suse.de>
Fri, 25 Apr 2008 04:16:50 +0000 (21:16 -0700)
Provide better comments about qh_completions() and QTD handling.
That code can be *VERY* confusing, since it's evolved over a few
years to cope with both hardware races and silicon quirks.

Remove two unlikely() annotations that match the GCC defaults
(and are thus pointless); add an "else" to highlight code flow.

This patch doesn't change driver behavior.

Signed-off-by: David Brownell <dbrownell@users.sourceforge.net>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
drivers/usb/host/ehci-q.c

index c0e752cffc683586fcf68d46b407ed7254b5a963..64942ec584c2309c26683a5e63ce7de3ca19d5ff 100644 (file)
@@ -336,11 +336,20 @@ qh_completions (struct ehci_hcd *ehci, struct ehci_qh *qh)
                /* always clean up qtds the hc de-activated */
                if ((token & QTD_STS_ACTIVE) == 0) {
 
+                       /* on STALL, error, and short reads this urb must
+                        * complete and all its qtds must be recycled.
+                        */
                        if ((token & QTD_STS_HALT) != 0) {
                                stopped = 1;
 
                        /* magic dummy for some short reads; qh won't advance.
                         * that silicon quirk can kick in with this dummy too.
+                        *
+                        * other short reads won't stop the queue, including
+                        * control transfers (status stage handles that) or
+                        * most other single-qtd reads ... the queue stops if
+                        * URB_SHORT_NOT_OK was set so the driver submitting
+                        * the urbs could clean it up.
                         */
                        } else if (IS_SHORT_READ (token)
                                        && !(qtd->hw_alt_next
@@ -354,18 +363,18 @@ qh_completions (struct ehci_hcd *ehci, struct ehci_qh *qh)
                                && HC_IS_RUNNING (ehci_to_hcd(ehci)->state))) {
                        break;
 
+               /* scan the whole queue for unlinks whenever it stops */
                } else {
                        stopped = 1;
 
-                       if (unlikely (!HC_IS_RUNNING (ehci_to_hcd(ehci)->state)))
+                       /* cancel everything if we halt, suspend, etc */
+                       if (!HC_IS_RUNNING(ehci_to_hcd(ehci)->state))
                                last_status = -ESHUTDOWN;
 
-                       /* ignore active urbs unless some previous qtd
-                        * for the urb faulted (including short read) or
-                        * its urb was canceled.  we may patch qh or qtds.
+                       /* this qtd is active; skip it unless a previous qtd
+                        * for its urb faulted, or its urb was canceled.
                         */
-                       if (likely(last_status == -EINPROGRESS &&
-                                       !urb->unlinked))
+                       else if (last_status == -EINPROGRESS && !urb->unlinked)
                                continue;
 
                        /* issue status after short control reads */
@@ -375,7 +384,7 @@ qh_completions (struct ehci_hcd *ehci, struct ehci_qh *qh)
                                continue;
                        }
 
-                       /* token in overlay may be most current */
+                       /* qh unlinked; token in overlay may be most current */
                        if (state == QH_STATE_IDLE
                                        && cpu_to_hc32(ehci, qtd->qtd_dma)
                                                == qh->hw_current)
@@ -402,11 +411,16 @@ halt:
                if (likely(last_status == -EINPROGRESS))
                        last_status = qtd_status;
 
+               /* if we're removing something not at the queue head,
+                * patch the hardware queue pointer.
+                */
                if (stopped && qtd->qtd_list.prev != &qh->qtd_list) {
                        last = list_entry (qtd->qtd_list.prev,
                                        struct ehci_qtd, qtd_list);
                        last->hw_next = qtd->hw_next;
                }
+
+               /* remove qtd; it's recycled after possible urb completion */
                list_del (&qtd->qtd_list);
                last = qtd;
        }
@@ -431,7 +445,15 @@ halt:
                        qh_refresh(ehci, qh);
                        break;
                case QH_STATE_LINKED:
-                       /* should be rare for periodic transfers,
+                       /* We won't refresh a QH that's linked (after the HC
+                        * stopped the queue).  That avoids a race:
+                        *  - HC reads first part of QH;
+                        *  - CPU updates that first part and the token;
+                        *  - HC reads rest of that QH, including token
+                        * Result:  HC gets an inconsistent image, and then
+                        * DMAs to/from the wrong memory (corrupting it).
+                        *
+                        * That should be rare for interrupt transfers,
                         * except maybe high bandwidth ...
                         */
                        if ((cpu_to_hc32(ehci, QH_SMASK)
@@ -549,6 +571,12 @@ qh_urb_transaction (
                this_qtd_len = qtd_fill(ehci, qtd, buf, len, token, maxpacket);
                len -= this_qtd_len;
                buf += this_qtd_len;
+
+               /*
+                * short reads advance to a "magic" dummy instead of the next
+                * qtd ... that forces the queue to stop, for manual cleanup.
+                * (this will usually be overridden later.)
+                */
                if (is_input)
                        qtd->hw_alt_next = ehci->async->hw_alt_next;
 
@@ -568,8 +596,10 @@ qh_urb_transaction (
                list_add_tail (&qtd->qtd_list, head);
        }
 
-       /* unless the bulk/interrupt caller wants a chance to clean
-        * up after short reads, hc should advance qh past this urb
+       /*
+        * unless the caller requires manual cleanup after short reads,
+        * have the alt_next mechanism keep the queue running after the
+        * last data qtd (the only one, for control and most other cases).
         */
        if (likely ((urb->transfer_flags & URB_SHORT_NOT_OK) == 0
                                || usb_pipecontrol (urb->pipe)))