]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
sky2: pci power savings
authorStephen Hemminger <shemminger@vyatta.com>
Thu, 15 May 2008 00:04:17 +0000 (17:04 -0700)
committerJeff Garzik <jgarzik@redhat.com>
Sat, 31 May 2008 02:19:17 +0000 (22:19 -0400)
Turn on special bits to save more power when device is shutdown.
Tested on a limited range of hardware, some of the bits are for hardware
that probably isn't even in production (like Yukon Supreme) and was ported
from the vendor driver.

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: Jeff Garzik <jgarzik@redhat.com>
drivers/net/sky2.c
drivers/net/sky2.h

index 59cb9cd00ad2ec4dd0832730e78bf25046eeb8fb..c83406f4f2a7618afab72b2f7aaf488225bebc94 100644 (file)
@@ -284,6 +284,86 @@ static void sky2_power_aux(struct sky2_hw *hw)
                             PC_VAUX_ON | PC_VCC_OFF));
 }
 
+static void sky2_power_state(struct sky2_hw *hw, pci_power_t state)
+{
+       u16 power_control = sky2_pci_read16(hw, hw->pm_cap + PCI_PM_CTRL);
+       int pex = pci_find_capability(hw->pdev, PCI_CAP_ID_EXP);
+       u32 reg;
+
+       sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_ON);
+
+       switch (state) {
+       case PCI_D0:
+               break;
+
+       case PCI_D1:
+               power_control |= 1;
+               break;
+
+       case PCI_D2:
+               power_control |= 2;
+               break;
+
+       case PCI_D3hot:
+       case PCI_D3cold:
+               power_control |= 3;
+               if (hw->flags & SKY2_HW_ADV_POWER_CTL) {
+                       /* additional power saving measurements */
+                       reg = sky2_pci_read32(hw, PCI_DEV_REG4);
+
+                       /* set gating core clock for LTSSM in L1 state */
+                       reg |= P_PEX_LTSSM_STAT(P_PEX_LTSSM_L1_STAT) |
+                               /* auto clock gated scheme controlled by CLKREQ */
+                               P_ASPM_A1_MODE_SELECT |
+                               /* enable Gate Root Core Clock */
+                               P_CLK_GATE_ROOT_COR_ENA;
+
+                       if (pex && (hw->flags & SKY2_HW_CLK_POWER)) {
+                               /* enable Clock Power Management (CLKREQ) */
+                               u16 ctrl = sky2_pci_read16(hw, pex + PCI_EXP_DEVCTL);
+
+                               ctrl |= PCI_EXP_DEVCTL_AUX_PME;
+                               sky2_pci_write16(hw, pex + PCI_EXP_DEVCTL, ctrl);
+                       } else
+                               /* force CLKREQ Enable in Our4 (A1b only) */
+                               reg |= P_ASPM_FORCE_CLKREQ_ENA;
+
+                       /* set Mask Register for Release/Gate Clock */
+                       sky2_pci_write32(hw, PCI_DEV_REG5,
+                                        P_REL_PCIE_EXIT_L1_ST | P_GAT_PCIE_ENTER_L1_ST |
+                                        P_REL_PCIE_RX_EX_IDLE | P_GAT_PCIE_RX_EL_IDLE |
+                                        P_REL_GPHY_LINK_UP | P_GAT_GPHY_LINK_DOWN);
+               } else
+                       sky2_write8(hw, B28_Y2_ASF_STAT_CMD, Y2_ASF_CLK_HALT);
+
+               /* put CPU into reset state */
+               sky2_write8(hw,  B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_RESET);
+               if (hw->chip_id == CHIP_ID_YUKON_SUPR && hw->chip_rev == CHIP_REV_YU_SU_A0)
+                       /* put CPU into halt state */
+                       sky2_write8(hw, B28_Y2_ASF_STAT_CMD, HCU_CCSR_ASF_HALTED);
+
+               if (pex && !(hw->flags & SKY2_HW_RAM_BUFFER)) {
+                       reg = sky2_pci_read32(hw, PCI_DEV_REG1);
+                       /* force to PCIe L1 */
+                       reg |= PCI_FORCE_PEX_L1;
+                       sky2_pci_write32(hw, PCI_DEV_REG1, reg);
+               }
+               break;
+
+       default:
+               dev_warn(&hw->pdev->dev, PFX "Invalid power state (%d) ",
+                      state);
+               return;
+       }
+
+       power_control |= PCI_PM_CTRL_PME_ENABLE;
+       /* Finally, set the new power state. */
+       sky2_pci_write32(hw, hw->pm_cap + PCI_PM_CTRL, power_control);
+
+       sky2_write8(hw, B2_TST_CTRL1, TST_CFG_WRITE_OFF);
+       sky2_pci_read32(hw, B0_CTST);
+}
+
 static void sky2_gmac_reset(struct sky2_hw *hw, unsigned port)
 {
        u16 reg;
@@ -2786,6 +2866,10 @@ static int __devinit sky2_init(struct sky2_hw *hw)
                hw->flags = SKY2_HW_GIGABIT
                        | SKY2_HW_NEWER_PHY
                        | SKY2_HW_ADV_POWER_CTL;
+
+               /* check for Rev. A1 dev 4200 */
+               if (sky2_read16(hw, Q_ADDR(Q_XA1, Q_WM)) == 0)
+                       hw->flags |= SKY2_HW_CLK_POWER;
                break;
 
        case CHIP_ID_YUKON_EX:
@@ -2836,6 +2920,11 @@ static int __devinit sky2_init(struct sky2_hw *hw)
        if (hw->pmd_type == 'L' || hw->pmd_type == 'S' || hw->pmd_type == 'P')
                hw->flags |= SKY2_HW_FIBRE_PHY;
 
+       hw->pm_cap = pci_find_capability(hw->pdev, PCI_CAP_ID_PM);
+       if (hw->pm_cap == 0) {
+               dev_err(&hw->pdev->dev, "cannot find PowerManagement capability\n");
+               return -EIO;
+       }
 
        hw->ports = 1;
        t8 = sky2_read8(hw, B2_Y2_HW_RES);
@@ -4407,7 +4496,7 @@ static int sky2_suspend(struct pci_dev *pdev, pm_message_t state)
 
        pci_save_state(pdev);
        pci_enable_wake(pdev, pci_choose_state(pdev, state), wol);
-       pci_set_power_state(pdev, pci_choose_state(pdev, state));
+       sky2_power_state(hw, pci_choose_state(pdev, state));
 
        return 0;
 }
@@ -4420,9 +4509,7 @@ static int sky2_resume(struct pci_dev *pdev)
        if (!hw)
                return 0;
 
-       err = pci_set_power_state(pdev, PCI_D0);
-       if (err)
-               goto out;
+       sky2_power_state(hw, PCI_D0);
 
        err = pci_restore_state(pdev);
        if (err)
@@ -4490,8 +4577,7 @@ static void sky2_shutdown(struct pci_dev *pdev)
        pci_enable_wake(pdev, PCI_D3cold, wol);
 
        pci_disable_device(pdev);
-       pci_set_power_state(pdev, PCI_D3hot);
-
+       sky2_power_state(hw, PCI_D3hot);
 }
 
 static struct pci_driver sky2_driver = {
index d63106cd74ba4184516a8117c88418fd5a927a79..1fa82bf029d9a312c507c4dd0df1798cd4e718e6 100644 (file)
@@ -28,6 +28,11 @@ enum pci_dev_reg_1 {
        PCI_Y2_PHY2_POWD = 1<<27, /* Set PHY 2 to Power Down (YUKON-2) */
        PCI_Y2_PHY1_POWD = 1<<26, /* Set PHY 1 to Power Down (YUKON-2) */
        PCI_Y2_PME_LEGACY= 1<<15, /* PCI Express legacy power management mode */
+
+       PCI_PHY_LNK_TIM_MSK= 3L<<8,/* Bit  9.. 8:       GPHY Link Trigger Timer */
+       PCI_ENA_L1_EVENT = 1<<7, /* Enable PEX L1 Event */
+       PCI_ENA_GPHY_LNK = 1<<6, /* Enable PEX L1 on GPHY Link down */
+       PCI_FORCE_PEX_L1 = 1<<5, /* Force to PEX L1 */
 };
 
 enum pci_dev_reg_2 {
@@ -45,7 +50,11 @@ enum pci_dev_reg_2 {
 
 /*     PCI_OUR_REG_4           32 bit  Our Register 4 (Yukon-ECU only) */
 enum pci_dev_reg_4 {
-                                       /* (Link Training & Status State Machine) */
+                               /* (Link Training & Status State Machine) */
+       P_PEX_LTSSM_STAT_MSK    = 0x7fL<<25,    /* Bit 31..25:  PEX LTSSM Mask */
+#define P_PEX_LTSSM_STAT(x)    ((x << 25) & P_PEX_LTSSM_STAT_MSK)
+       P_PEX_LTSSM_L1_STAT     = 0x34,
+       P_PEX_LTSSM_DET_STAT    = 0x01,
        P_TIMER_VALUE_MSK       = 0xffL<<16,    /* Bit 23..16:  Timer Value Mask */
                                        /* (Active State Power Management) */
        P_FORCE_ASPM_REQUEST    = 1<<15, /* Force ASPM Request (A1 only) */
@@ -454,6 +463,9 @@ enum yukon_ex_rev {
        CHIP_REV_YU_EX_A0    = 1,
        CHIP_REV_YU_EX_B0    = 2,
 };
+enum yukon_supr_rev {
+       CHIP_REV_YU_SU_A0    = 0,
+};
 
 
 /*     B2_Y2_CLK_GATE   8 bit  Clock Gating (Yukon-2 only) */
@@ -2059,7 +2071,9 @@ struct sky2_hw {
 #define SKY2_HW_NEW_LE         0x00000020      /* new LSOv2 format */
 #define SKY2_HW_AUTO_TX_SUM    0x00000040      /* new IP decode for Tx */
 #define SKY2_HW_ADV_POWER_CTL  0x00000080      /* additional PHY power regs */
+#define SKY2_HW_CLK_POWER      0x00000100      /* clock power management */
 
+       int                  pm_cap;
        u8                   chip_id;
        u8                   chip_rev;
        u8                   pmd_type;