]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
imxfb: remove ifdefs
authorSascha Hauer <s.hauer@pengutronix.de>
Wed, 23 May 2007 20:57:51 +0000 (13:57 -0700)
committerLinus Torvalds <torvalds@woody.linux-foundation.org>
Thu, 24 May 2007 03:14:13 +0000 (20:14 -0700)
Here are some small fixes for the imxfb framebuffer driver:

 - remove ifndef for MX1FS2 platform which is not present in the kernel.
 - REV, CLS, PS and SPL_SPR are only needed with some sharp displays.
   Only setup the corresponding io pins when such a display is connected.

Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
Signed-off-by: Antonino Daplas <adaplas@gmail.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
drivers/video/imxfb.c

index 267c1ff9ebd9b8b841bc448cbf8b0005c9df1710..6cdf269da4939c8fe1afa258cac0d5df59d7cb28 100644 (file)
@@ -394,26 +394,18 @@ static void imxfb_setup_gpio(struct imxfb_info *fbi)
 
        /* initialize GPIOs */
        imx_gpio_mode(PD6_PF_LSCLK);
-       imx_gpio_mode(PD10_PF_SPL_SPR);
        imx_gpio_mode(PD11_PF_CONTRAST);
        imx_gpio_mode(PD14_PF_FLM_VSYNC);
        imx_gpio_mode(PD13_PF_LP_HSYNC);
-       imx_gpio_mode(PD7_PF_REV);
-       imx_gpio_mode(PD8_PF_CLS);
-
-#ifndef CONFIG_MACH_PIMX1
-       /* on PiMX1 used as buffers enable signal
-        */
-       imx_gpio_mode(PD9_PF_PS);
-#endif
-
-#ifndef CONFIG_MACH_MX1FS2
-       /* on mx1fs2 this pin is used to (de)activate the display, so we need
-        * it as a normal gpio
-        */
        imx_gpio_mode(PD12_PF_ACD_OE);
-#endif
 
+       /* These are only needed for Sharp HR TFT displays */
+       if (fbi->pcr & PCR_SHARP) {
+               imx_gpio_mode(PD7_PF_REV);
+               imx_gpio_mode(PD8_PF_CLS);
+               imx_gpio_mode(PD9_PF_PS);
+               imx_gpio_mode(PD10_PF_SPL_SPR);
+       }
 }
 
 #ifdef CONFIG_PM
@@ -499,6 +491,7 @@ static int __init imxfb_init_fbinfo(struct device *dev)
        info->var.sync                  = inf->sync;
        info->var.grayscale             = inf->cmap_greyscale;
        fbi->cmap_inverse               = inf->cmap_inverse;
+       fbi->cmap_static                = inf->cmap_static;
        fbi->pcr                        = inf->pcr;
        fbi->lscr1                      = inf->lscr1;
        fbi->dmacr                      = inf->dmacr;