netdev: convert eexpro to net_device_ops

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/eepro.c b/drivers/net/eepro.c
index e187c88ae1450329a51da2ba64024dd55da2c3e0..cc2ab6412c7382484073f405306a4a76775b59bd 100644 (file)
--- a/drivers/net/eepro.c
+++ b/drivers/net/eepro.c
@@ -739,6 +739,17 @@ static void __init eepro_print_info (struct net_device *dev)
 
 static const struct ethtool_ops eepro_ethtool_ops;
 
+static const struct net_device_ops eepro_netdev_ops = {
+       .ndo_open               = eepro_open,
+       .ndo_stop               = eepro_close,
+       .ndo_start_xmit         = eepro_send_packet,
+       .ndo_set_multicast_list = set_multicast_list,
+       .ndo_tx_timeout         = eepro_tx_timeout,
+       .ndo_change_mtu         = eth_change_mtu,
+       .ndo_set_mac_address    = eth_mac_addr,
+       .ndo_validate_addr      = eth_validate_addr,
+};
+
 /* This is the real probe routine.  Linux has a history of friendly device
    probes on the ISA bus.  A good device probe avoids doing writes, and
    verifies that the correct device exists and functions.  */
@@ -851,11 +862,7 @@ static int __init eepro_probe1(struct net_device *dev, int autoprobe)
                }
        }
 
-       dev->open               = eepro_open;
-       dev->stop               = eepro_close;
-       dev->hard_start_xmit    = eepro_send_packet;
-       dev->set_multicast_list = &set_multicast_list;
-       dev->tx_timeout         = eepro_tx_timeout;
+       dev->netdev_ops         = &eepro_netdev_ops;
        dev->watchdog_timeo     = TX_TIMEOUT;
        dev->ethtool_ops        = &eepro_ethtool_ops;