#define CR_MAC_PS_STATE CTL_REG(0x050C)
#define CR_INTERRUPT CTL_REG(0x0510)
-#define INT_TX_COMPLETE 0x00000001
-#define INT_RX_COMPLETE 0x00000002
-#define INT_RETRY_FAIL 0x00000004
-#define INT_WAKEUP 0x00000008
-#define INT_DTIM_NOTIFY 0x00000020
-#define INT_CFG_NEXT_BCN 0x00000040
-#define INT_BUS_ABORT 0x00000080
-#define INT_TX_FIFO_READY 0x00000100
-#define INT_UART 0x00000200
-#define INT_TX_COMPLETE_EN 0x00010000
-#define INT_RX_COMPLETE_EN 0x00020000
-#define INT_RETRY_FAIL_EN 0x00040000
-#define INT_WAKEUP_EN 0x00080000
-#define INT_DTIM_NOTIFY_EN 0x00200000
-#define INT_CFG_NEXT_BCN_EN 0x00400000
-#define INT_BUS_ABORT_EN 0x00800000
-#define INT_TX_FIFO_READY_EN 0x01000000
-#define INT_UART_EN 0x02000000
+#define INT_TX_COMPLETE (1 << 0)
+#define INT_RX_COMPLETE (1 << 1)
+#define INT_RETRY_FAIL (1 << 2)
+#define INT_WAKEUP (1 << 3)
+#define INT_DTIM_NOTIFY (1 << 5)
+#define INT_CFG_NEXT_BCN (1 << 6)
+#define INT_BUS_ABORT (1 << 7)
+#define INT_TX_FIFO_READY (1 << 8)
+#define INT_UART (1 << 9)
+#define INT_TX_COMPLETE_EN (1 << 16)
+#define INT_RX_COMPLETE_EN (1 << 17)
+#define INT_RETRY_FAIL_EN (1 << 18)
+#define INT_WAKEUP_EN (1 << 19)
+#define INT_DTIM_NOTIFY_EN (1 << 21)
+#define INT_CFG_NEXT_BCN_EN (1 << 22)
+#define INT_BUS_ABORT_EN (1 << 23)
+#define INT_TX_FIFO_READY_EN (1 << 24)
+#define INT_UART_EN (1 << 25)
#define CR_TSF_LOW_PART CTL_REG(0x0514)
#define CR_TSF_HIGH_PART CTL_REG(0x0518)
* device will use a rate in this table that is less than or equal to the rate
* of the incoming frame which prompted the response */
#define CR_BASIC_RATE_TBL CTL_REG(0x0630)
-#define CR_RATE_1M 0x0001 /* 802.11b */
-#define CR_RATE_2M 0x0002 /* 802.11b */
-#define CR_RATE_5_5M 0x0004 /* 802.11b */
-#define CR_RATE_11M 0x0008 /* 802.11b */
-#define CR_RATE_6M 0x0100 /* 802.11g */
-#define CR_RATE_9M 0x0200 /* 802.11g */
-#define CR_RATE_12M 0x0400 /* 802.11g */
-#define CR_RATE_18M 0x0800 /* 802.11g */
-#define CR_RATE_24M 0x1000 /* 802.11g */
-#define CR_RATE_36M 0x2000 /* 802.11g */
-#define CR_RATE_48M 0x4000 /* 802.11g */
-#define CR_RATE_54M 0x8000 /* 802.11g */
+#define CR_RATE_1M (1 << 0) /* 802.11b */
+#define CR_RATE_2M (1 << 1) /* 802.11b */
+#define CR_RATE_5_5M (1 << 2) /* 802.11b */
+#define CR_RATE_11M (1 << 3) /* 802.11b */
+#define CR_RATE_6M (1 << 8) /* 802.11g */
+#define CR_RATE_9M (1 << 9) /* 802.11g */
+#define CR_RATE_12M (1 << 10) /* 802.11g */
+#define CR_RATE_18M (1 << 11) /* 802.11g */
+#define CR_RATE_24M (1 << 12) /* 802.11g */
+#define CR_RATE_36M (1 << 13) /* 802.11g */
+#define CR_RATE_48M (1 << 14) /* 802.11g */
+#define CR_RATE_54M (1 << 15) /* 802.11g */
#define CR_RATES_80211G 0xff00
#define CR_RATES_80211B 0x000f
/* register for controlling the LEDS */
#define CR_LED CTL_REG(0x0644)
/* masks for controlling LEDs */
-#define LED1 0x0100
-#define LED2 0x0200
-#define LED_SW 0x0400
+#define LED1 (1 << 8)
+#define LED2 (1 << 9)
+#define LED_SW (1 << 10)
/* Seems to indicate that the configuration is over.
*/
* registers, so one could argue it is a LOCK bit. But calling it
* LOCK_PHY_REGS makes it confusing.
*/
-#define UNLOCK_PHY_REGS 0x0080
+#define UNLOCK_PHY_REGS (1 << 7)
#define CR_DEVICE_STATE CTL_REG(0x0684)
#define CR_UNDERRUN_CNT CTL_REG(0x0688)
#define CR_RX_FILTER CTL_REG(0x068c)
-#define RX_FILTER_ASSOC_RESPONSE 0x0002
-#define RX_FILTER_REASSOC_RESPONSE 0x0008
-#define RX_FILTER_PROBE_RESPONSE 0x0020
-#define RX_FILTER_BEACON 0x0100
-#define RX_FILTER_DISASSOC 0x0400
-#define RX_FILTER_AUTH 0x0800
+#define RX_FILTER_ASSOC_RESPONSE (1 << 1)
+#define RX_FILTER_REASSOC_RESPONSE (1 << 3)
+#define RX_FILTER_PROBE_RESPONSE (1 << 5)
+#define RX_FILTER_BEACON (1 << 8)
+#define RX_FILTER_DISASSOC (1 << 10)
+#define RX_FILTER_AUTH (1 << 11)
#define AP_RX_FILTER 0x0400feff
#define STA_RX_FILTER 0x0000ffff
zd_chip_set_channel(&mac->chip, channel);
}
-/* TODO: Should not work in Managed mode. */
int zd_mac_request_channel(struct zd_mac *mac, u8 channel)
{
unsigned long lock_flags;
(netdev->flags & IFF_PROMISC);
}
-/* Filters receiving packets. If it returns 1 send it to ieee80211_rx, if 0
- * return. If an error is detected -EINVAL is returned. ieee80211_rx_mgt() is
- * called here.
+/* Filters received packets. The function returns 1 if the packet should be
+ * forwarded to ieee80211_rx(). If the packet should be ignored the function
+ * returns 0. If an invalid packet is found the function returns -EINVAL.
+ *
+ * The function calls ieee80211_rx_mgt() directly.
*
* It has been based on ieee80211_rx_any.
*/
ieee80211_rx_mgt(ieee, hdr, stats);
return 0;
case IEEE80211_FTYPE_CTL:
- /* Ignore invalid short buffers */
return 0;
case IEEE80211_FTYPE_DATA:
+ /* Ignore invalid short buffers */
if (length < sizeof(struct ieee80211_hdr_3addr))
return -EINVAL;
return is_data_packet_for_us(ieee, hdr);
return iw_stats;
}
-#ifdef DEBUG
-static const char* decryption_types[] = {
- [ZD_RX_NO_WEP] = "none",
- [ZD_RX_WEP64] = "WEP64",
- [ZD_RX_TKIP] = "TKIP",
- [ZD_RX_AES] = "AES",
- [ZD_RX_WEP128] = "WEP128",
- [ZD_RX_WEP256] = "WEP256",
-};
-
-static const char *decryption_type_string(u8 type)
-{
- const char *s;
-
- if (type < ARRAY_SIZE(decryption_types)) {
- s = decryption_types[type];
- } else {
- s = NULL;
- }
- return s ? s : "unknown";
-}
-
-static int is_ofdm(u8 frame_status)
-{
- return (frame_status & ZD_RX_OFDM);
-}
-
-void zd_dump_rx_status(const struct rx_status *status)
-{
- const char* modulation;
- u8 quality;
-
- if (is_ofdm(status->frame_status)) {
- modulation = "ofdm";
- quality = status->signal_quality_ofdm;
- } else {
- modulation = "cck";
- quality = status->signal_quality_cck;
- }
- pr_debug("rx status %s strength %#04x qual %#04x decryption %s\n",
- modulation, status->signal_strength, quality,
- decryption_type_string(status->decryption_type));
- if (status->frame_status & ZD_RX_ERROR) {
- pr_debug("rx error %s%s%s%s%s%s\n",
- (status->frame_status & ZD_RX_TIMEOUT_ERROR) ?
- "timeout " : "",
- (status->frame_status & ZD_RX_FIFO_OVERRUN_ERROR) ?
- "fifo " : "",
- (status->frame_status & ZD_RX_DECRYPTION_ERROR) ?
- "decryption " : "",
- (status->frame_status & ZD_RX_CRC32_ERROR) ?
- "crc32 " : "",
- (status->frame_status & ZD_RX_NO_ADDR1_MATCH_ERROR) ?
- "addr1 " : "",
- (status->frame_status & ZD_RX_CRC16_ERROR) ?
- "crc16" : "");
- }
-}
-#endif /* DEBUG */
-
#define LINK_LED_WORK_DELAY HZ
static void link_led_handler(void *p)
projects / linux-2.6-omap-h63xx.git / commitdiff