USB: debug port converter does not accept more than 8 byte packets

USB debug port only supports 8 byte rx/tx packets. Although spec implies that
"if a packet larger than eight bytes is received from the remote computer, the
device must break the larger packet into eight-byte packets before sending the
data to the Debug Port", the real PLX NET20DC device does not handle it right -
data is corrupted on debug port end if serial interface sends >8 byte urbs.
Patch below fixes the issue by limiting tx urb to 8 byte.

Signed off by: Aleks Gorelov <dared1st@yahoo.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

diff --git a/drivers/usb/serial/usb_debug.c b/drivers/usb/serial/usb_debug.c
index f9fc926b56d87896577280da6c7d8b39d6b10cc6..9ca4d4db1dddc80c7d91b499f7258a168c3be5be 100644 (file)
--- a/drivers/usb/serial/usb_debug.c
+++ b/drivers/usb/serial/usb_debug.c
@@ -15,6 +15,8 @@
 #include <linux/usb.h>
 #include <linux/usb/serial.h>
 
+#define USB_DEBUG_MAX_PACKET_SIZE      8
+
 static struct usb_device_id id_table [] = {
        { USB_DEVICE(0x0525, 0x127a) },
        { },
@@ -29,6 +31,12 @@ static struct usb_driver debug_driver = {
        .no_dynamic_id =        1,
 };
 
+int usb_debug_open(struct usb_serial_port *port, struct file *filp)
+{
+       port->bulk_out_size = USB_DEBUG_MAX_PACKET_SIZE;
+       return usb_serial_generic_open(port, filp);
+}
+
 static struct usb_serial_driver debug_device = {
        .driver = {
                .owner =        THIS_MODULE,
@@ -36,6 +44,7 @@ static struct usb_serial_driver debug_device = {
        },
        .id_table =             id_table,
        .num_ports =            1,
+       .open =                 usb_debug_open,
 };
 
 static int __init debug_init(void)