]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
[B43]: Remove the "radio hw enabled" message on startup.
authorMichael Buesch <mb@bu3sch.de>
Thu, 20 Sep 2007 20:12:58 +0000 (22:12 +0200)
committerDavid S. Miller <davem@sunset.davemloft.net>
Wed, 10 Oct 2007 23:52:24 +0000 (16:52 -0700)
This message is useless. Only report state changes.

Cc: Larry Finger <larry.finger@lwfinger.net>
Signed-off-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/wireless/b43/main.c

index 1390f41425f1abd4c330465f1a688336972b19a4..cc5285407e88ae2deb8034f72767b4414af0455f 100644 (file)
@@ -2227,9 +2227,6 @@ static int b43_chip_init(struct b43_wldev *dev)
        if (err)
                goto err_gpio_cleanup;
        b43_radio_turn_on(dev);
-       dev->radio_hw_enable = b43_is_hw_radio_enabled(dev);
-       b43dbg(dev->wl, "Radio %s by hardware\n",
-              dev->radio_hw_enable ? "enabled" : "disabled");
 
        b43_write16(dev, 0x03E6, 0x0000);
        err = b43_phy_init(dev);
@@ -3252,6 +3249,9 @@ static void setup_struct_wldev_for_init(struct b43_wldev *dev)
 {
        /* Flags */
        dev->reg124_set_0x4 = 0;
+       /* Assume the radio is enabled. If it's not enabled, the state will
+        * immediately get fixed on the first periodic work run. */
+       dev->radio_hw_enable = 1;
 
        /* Stats */
        memset(&dev->stats, 0, sizeof(dev->stats));