[SCSI] qla2xxx: Correct synchronization of software/firmware fcport states.

Greg Wettstein (greg@enjellic.com) noted:

	http://article.gmane.org/gmane.linux.scsi/43409

on a reboot of a previously recognized SCST target, the initiator
driver would be unable to re-recognize the device as a target.
It turns out that prior to the SCST software reloading and
returning it's "target-capable" abilities in the PRLI payload,
the HBA would be re-initialized as an initiator-only type port.
Since initiators typically classify themselves as an FCP-2
capable device, both software and firmware do not perform an
explicit logout during port-loss.  Unfortunately, as can be seen
by the failure case, when the port (now target-capable) returns,
firmware performs an ADISC without a follow-on PRLI, leaving
stale 'initiator-only' data in the firmware's port database.

Correct the discrepancy by performing the explicit logout during
the transport's request to terminate-rport-io, thus synchronizing
port states and ensuring a follow-on PRLI is performed.

Reported-by: Greg Wettstein <greg@enjellic.com>
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Cc: Stable Tree <stable@kernel.org>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

diff --git a/drivers/scsi/qla2xxx/qla_attr.c b/drivers/scsi/qla2xxx/qla_attr.c
index a319a20ed440748da301b5a268941d5e57d00294..45e7dcb4b34d8b276edae17cf56a13c749317fa3 100644 (file)
--- a/drivers/scsi/qla2xxx/qla_attr.c
+++ b/drivers/scsi/qla2xxx/qla_attr.c
@@ -993,6 +993,17 @@ qla2x00_terminate_rport_io(struct fc_rport *rport)
 {
        fc_port_t *fcport = *(fc_port_t **)rport->dd_data;
 
+       /*
+        * At this point all fcport's software-states are cleared.  Perform any
+        * final cleanup of firmware resources (PCBs and XCBs).
+        */
+       if (fcport->loop_id != FC_NO_LOOP_ID) {
+               fcport->ha->isp_ops->fabric_logout(fcport->ha, fcport->loop_id,
+                   fcport->d_id.b.domain, fcport->d_id.b.area,
+                   fcport->d_id.b.al_pa);
+               fcport->loop_id = FC_NO_LOOP_ID;
+       }
+
        qla2x00_abort_fcport_cmds(fcport);
        scsi_target_unblock(&rport->dev);
 }