]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
[SCSI] 3ware 9000: Add support for 9550SX controllers
authoradam radford <aradford@gmail.com>
Thu, 22 Sep 2005 00:20:14 +0000 (17:20 -0700)
committerJames Bottomley <jejb@mulgrave.(none)>
Sun, 25 Sep 2005 14:36:26 +0000 (09:36 -0500)
Signed-off-by: Adam Radford <linuxraid@amcc.com>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
drivers/scsi/3w-9xxx.c
drivers/scsi/3w-9xxx.h

index a6ac61611f35296c2a1d4402940075d10e38dc0a..a748fbfb66927dc9c54903abcec1d7a585a5b240 100644 (file)
@@ -60,6 +60,7 @@
                  Remove un-needed eh_abort handler.
                  Add support for embedded firmware error strings.
    2.26.02.003 - Correctly handle single sgl's with use_sg=1.
+   2.26.02.004 - Add support for 9550SX controllers.
 */
 
 #include <linux/module.h>
@@ -82,7 +83,7 @@
 #include "3w-9xxx.h"
 
 /* Globals */
-#define TW_DRIVER_VERSION "2.26.02.003"
+#define TW_DRIVER_VERSION "2.26.02.004"
 static TW_Device_Extension *twa_device_extension_list[TW_MAX_SLOT];
 static unsigned int twa_device_extension_count;
 static int twa_major = -1;
@@ -892,11 +893,6 @@ static int twa_decode_bits(TW_Device_Extension *tw_dev, u32 status_reg_value)
                writel(TW_CONTROL_CLEAR_QUEUE_ERROR, TW_CONTROL_REG_ADDR(tw_dev));
        }
 
-       if (status_reg_value & TW_STATUS_SBUF_WRITE_ERROR) {
-               TW_PRINTK(tw_dev->host, TW_DRIVER, 0xf, "SBUF Write Error: clearing");
-               writel(TW_CONTROL_CLEAR_SBUF_WRITE_ERROR, TW_CONTROL_REG_ADDR(tw_dev));
-       }
-
        if (status_reg_value & TW_STATUS_MICROCONTROLLER_ERROR) {
                if (tw_dev->reset_print == 0) {
                        TW_PRINTK(tw_dev->host, TW_DRIVER, 0x10, "Microcontroller Error: clearing");
@@ -930,6 +926,36 @@ out:
        return retval;
 } /* End twa_empty_response_queue() */
 
+/* This function will clear the pchip/response queue on 9550SX */
+static int twa_empty_response_queue_large(TW_Device_Extension *tw_dev)
+{
+       u32 status_reg_value, response_que_value;
+       int count = 0, retval = 1;
+
+       if (tw_dev->tw_pci_dev->device == PCI_DEVICE_ID_3WARE_9550SX) {
+               status_reg_value = readl(TW_STATUS_REG_ADDR(tw_dev));
+
+               while (((status_reg_value & TW_STATUS_RESPONSE_QUEUE_EMPTY) == 0) && (count < TW_MAX_RESPONSE_DRAIN)) {
+                       response_que_value = readl(TW_RESPONSE_QUEUE_REG_ADDR_LARGE(tw_dev));
+                       if ((response_que_value & TW_9550SX_DRAIN_COMPLETED) == TW_9550SX_DRAIN_COMPLETED) {
+                               /* P-chip settle time */
+                               msleep(500);
+                               retval = 0;
+                               goto out;
+                       }
+                       status_reg_value = readl(TW_STATUS_REG_ADDR(tw_dev));
+                       count++;
+               }
+               if (count == TW_MAX_RESPONSE_DRAIN)
+                       goto out;
+               
+               retval = 0;
+       } else
+               retval = 0;
+out:
+       return retval;
+} /* End twa_empty_response_queue_large() */
+
 /* This function passes sense keys from firmware to scsi layer */
 static int twa_fill_sense(TW_Device_Extension *tw_dev, int request_id, int copy_sense, int print_host)
 {
@@ -1613,8 +1639,16 @@ static int twa_reset_sequence(TW_Device_Extension *tw_dev, int soft_reset)
        int tries = 0, retval = 1, flashed = 0, do_soft_reset = soft_reset;
 
        while (tries < TW_MAX_RESET_TRIES) {
-               if (do_soft_reset)
+               if (do_soft_reset) {
                        TW_SOFT_RESET(tw_dev);
+                       /* Clear pchip/response queue on 9550SX */
+                       if (twa_empty_response_queue_large(tw_dev)) {
+                               TW_PRINTK(tw_dev->host, TW_DRIVER, 0x36, "Response queue (large) empty failed during reset sequence");
+                               do_soft_reset = 1;
+                               tries++;
+                               continue;
+                       }
+               }
 
                /* Make sure controller is in a good state */
                if (twa_poll_status(tw_dev, TW_STATUS_MICROCONTROLLER_READY | (do_soft_reset == 1 ? TW_STATUS_ATTENTION_INTERRUPT : 0), 60)) {
@@ -2034,7 +2068,10 @@ static int __devinit twa_probe(struct pci_dev *pdev, const struct pci_device_id
                goto out_free_device_extension;
        }
 
-       mem_addr = pci_resource_start(pdev, 1);
+       if (pdev->device == PCI_DEVICE_ID_3WARE_9000)
+               mem_addr = pci_resource_start(pdev, 1);
+       else
+               mem_addr = pci_resource_start(pdev, 2);
 
        /* Save base address */
        tw_dev->base_addr = ioremap(mem_addr, PAGE_SIZE);
@@ -2148,6 +2185,8 @@ static void twa_remove(struct pci_dev *pdev)
 static struct pci_device_id twa_pci_tbl[] __devinitdata = {
        { PCI_VENDOR_ID_3WARE, PCI_DEVICE_ID_3WARE_9000,
          PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
+       { PCI_VENDOR_ID_3WARE, PCI_DEVICE_ID_3WARE_9550SX,
+         PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
        { }
 };
 MODULE_DEVICE_TABLE(pci, twa_pci_tbl);
index 8c8ecbed3b58708cf64583c86d478094aafa4522..46f22cdc82985d91bbad87fe3df4a0e8e090cc5d 100644 (file)
@@ -267,7 +267,6 @@ static twa_message_type twa_error_table[] = {
 #define TW_CONTROL_CLEAR_PARITY_ERROR          0x00800000
 #define TW_CONTROL_CLEAR_QUEUE_ERROR           0x00400000
 #define TW_CONTROL_CLEAR_PCI_ABORT             0x00100000
-#define TW_CONTROL_CLEAR_SBUF_WRITE_ERROR      0x00000008
 
 /* Status register bit definitions */
 #define TW_STATUS_MAJOR_VERSION_MASK          0xF0000000
@@ -285,9 +284,8 @@ static twa_message_type twa_error_table[] = {
 #define TW_STATUS_MICROCONTROLLER_READY               0x00002000
 #define TW_STATUS_COMMAND_QUEUE_EMPTY         0x00001000
 #define TW_STATUS_EXPECTED_BITS                       0x00002000
-#define TW_STATUS_UNEXPECTED_BITS             0x00F00008
-#define TW_STATUS_SBUF_WRITE_ERROR             0x00000008
-#define TW_STATUS_VALID_INTERRUPT              0x00DF0008
+#define TW_STATUS_UNEXPECTED_BITS             0x00F00000
+#define TW_STATUS_VALID_INTERRUPT              0x00DF0000
 
 /* RESPONSE QUEUE BIT DEFINITIONS */
 #define TW_RESPONSE_ID_MASK                   0x00000FF0
@@ -324,9 +322,9 @@ static twa_message_type twa_error_table[] = {
 
 /* Compatibility defines */
 #define TW_9000_ARCH_ID 0x5
-#define TW_CURRENT_DRIVER_SRL 28
-#define TW_CURRENT_DRIVER_BUILD 9
-#define TW_CURRENT_DRIVER_BRANCH 4
+#define TW_CURRENT_DRIVER_SRL 30
+#define TW_CURRENT_DRIVER_BUILD 80
+#define TW_CURRENT_DRIVER_BRANCH 0
 
 /* Phase defines */
 #define TW_PHASE_INITIAL 0
@@ -334,6 +332,7 @@ static twa_message_type twa_error_table[] = {
 #define TW_PHASE_SGLIST  2
 
 /* Misc defines */
+#define TW_9550SX_DRAIN_COMPLETED            0xFFFF
 #define TW_SECTOR_SIZE                        512
 #define TW_ALIGNMENT_9000                     4  /* 4 bytes */
 #define TW_ALIGNMENT_9000_SGL                 0x3
@@ -417,6 +416,9 @@ static twa_message_type twa_error_table[] = {
 #ifndef PCI_DEVICE_ID_3WARE_9000
 #define PCI_DEVICE_ID_3WARE_9000 0x1002
 #endif
+#ifndef PCI_DEVICE_ID_3WARE_9550SX
+#define PCI_DEVICE_ID_3WARE_9550SX 0x1003
+#endif
 
 /* Bitmask macros to eliminate bitfields */
 
@@ -443,6 +445,7 @@ static twa_message_type twa_error_table[] = {
 #define TW_STATUS_REG_ADDR(x) ((unsigned char __iomem *)x->base_addr + 0x4)
 #define TW_COMMAND_QUEUE_REG_ADDR(x) (sizeof(dma_addr_t) > 4 ? ((unsigned char __iomem *)x->base_addr + 0x20) : ((unsigned char __iomem *)x->base_addr + 0x8))
 #define TW_RESPONSE_QUEUE_REG_ADDR(x) ((unsigned char __iomem *)x->base_addr + 0xC)
+#define TW_RESPONSE_QUEUE_REG_ADDR_LARGE(x) ((unsigned char __iomem *)x->base_addr + 0x30)
 #define TW_CLEAR_ALL_INTERRUPTS(x) (writel(TW_STATUS_VALID_INTERRUPT, TW_CONTROL_REG_ADDR(x)))
 #define TW_CLEAR_ATTENTION_INTERRUPT(x) (writel(TW_CONTROL_CLEAR_ATTENTION_INTERRUPT, TW_CONTROL_REG_ADDR(x)))
 #define TW_CLEAR_HOST_INTERRUPT(x) (writel(TW_CONTROL_CLEAR_HOST_INTERRUPT, TW_CONTROL_REG_ADDR(x)))