When I implemented the DECLARE_PER_CPU(var) macros, I was careful that
people couldn't use "var" in a non-percpu context, by prepending
percpu__. I never considered that this would allow them to overload
the same name for a per-cpu and a non-percpu variable.
It is only one of many horrors in the i386 boot code, but let's rename
the non-perpcu cpu_gdt_descr to early_gdt_descr (not boot_gdt_descr,
that's something else...)
Signed-off-by: Rusty Russell <rusty@rustcorp.com.au>
Signed-off-by: Andi Kleen <ak@suse.de>
===================================================================
call check_x87
call setup_pda
- lgdt cpu_gdt_descr
+ lgdt early_gdt_descr
lidt idt_descr
ljmp $(__KERNEL_CS),$1f
1: movl $(__KERNEL_DS),%eax # reload all the segment registers
movl start_pda, %eax
/* slot the PDA address into the GDT */
- mov cpu_gdt_descr+2, %ecx
+ mov early_gdt_descr+2, %ecx
mov %ax, (__KERNEL_PDA+0+2)(%ecx) /* base & 0x0000ffff */
shr $16, %eax
mov %al, (__KERNEL_PDA+4+0)(%ecx) /* base & 0x00ff0000 */
# boot GDT descriptor (later on used by CPU#0):
.word 0 # 32 bit align gdt_desc.address
-ENTRY(cpu_gdt_descr)
+ENTRY(early_gdt_descr)
.word GDT_ENTRIES*8-1
.long cpu_gdt_table
unsigned short ss;
} stack_start;
extern struct i386_pda *start_pda;
-extern struct Xgt_desc_struct cpu_gdt_descr;
#ifdef CONFIG_NUMA
extern struct Xgt_desc_struct idt_descr;
DECLARE_PER_CPU(struct Xgt_desc_struct, cpu_gdt_descr);
-
+extern struct Xgt_desc_struct early_gdt_descr;
static inline struct desc_struct *get_cpu_gdt_table(unsigned int cpu)
{