]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
[LIBERTAS]: fix interrupts in CF driver
authorRyan Mallon <ryan@bluewatersys.com>
Fri, 7 Sep 2007 01:32:42 +0000 (21:32 -0400)
committerDavid S. Miller <davem@sunset.davemloft.net>
Wed, 10 Oct 2007 23:52:27 +0000 (16:52 -0700)
The following patch fixes the tx transmit timeout problem, which is
caused by the interrupts being incorrectly check and masked. The patch
moves the interrupt masking code so that interrupts are enabled only
when the driver is registered and only disabled when the driver is
unregistered.

Signed-off-by: Ryan Mallon <ryan@bluewatersys.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/net/wireless/libertas/if_cs.c

index 364da4cac2147d2423b10fc1c8772db9a217364b..e74ec5c309bec341f5a13fa139cf535ae6d137e1 100644 (file)
@@ -248,22 +248,26 @@ static irqreturn_t if_cs_interrupt(int irq, void *data)
        lbs_deb_enter(LBS_DEB_CS);
 
        int_cause = if_cs_read16(card, IF_CS_C_INT_CAUSE);
-       switch (int_cause) {
-       case 0x0000:
-               /* not for us */
+       if(int_cause == 0x0) {
+               /* Not for us */
                return IRQ_NONE;
-       case 0xffff:
-               /* if one reads junk, then probably the card was removed */
+
+       } else if(int_cause == 0xffff) {
+               /* Read in junk, the card has probably been removed */
                card->priv->adapter->surpriseremoved = 1;
-               break;
-       case IF_CS_H_IC_TX_OVER:
-               if (card->priv->adapter->connect_status == LIBERTAS_CONNECTED)
-                       netif_wake_queue(card->priv->dev);
-               /* fallthrought */
-       default:
+
+       } else {
+               if(int_cause & IF_CS_H_IC_TX_OVER) {
+                       card->priv->dnld_sent = DNLD_RES_RECEIVED;
+                       if (!card->priv->adapter->cur_cmd)
+                               wake_up_interruptible(&card->priv->waitq);
+
+                       if (card->priv->adapter->connect_status == LIBERTAS_CONNECTED)
+                               netif_wake_queue(card->priv->dev);
+               }
+
                /* clear interrupt */
                if_cs_write16(card, IF_CS_C_INT_CAUSE, int_cause & IF_CS_C_IC_MASK);
-               if_cs_disable_ints(card);
        }
 
        libertas_interrupt(card->priv->dev);
@@ -652,7 +656,6 @@ static int if_cs_get_int_status(wlan_private *priv, u8 *ireg)
        if_cs_write16(card, IF_CS_C_INT_CAUSE, int_cause);
 
        *ireg = if_cs_read16(card, IF_CS_C_STATUS) & IF_CS_C_S_MASK;
-       if_cs_enable_ints(card);
 
        if (!*ireg)
                goto sbi_get_int_status_exit;
@@ -841,7 +844,6 @@ static int if_cs_probe(struct pcmcia_device *p_dev)
               p_dev->irq.AssignedIRQ, p_dev->io.BasePort1,
               p_dev->io.BasePort1 + p_dev->io.NumPorts1 - 1);
 
-       if_cs_enable_ints(card);
 
        /* Load the firmware early, before calling into libertas.ko */
        ret = if_cs_prog_helper(card);
@@ -874,6 +876,8 @@ static int if_cs_probe(struct pcmcia_device *p_dev)
                goto out3;
        }
 
+       if_cs_enable_ints(card);
+
        /* And finally bring the card up */
        if (libertas_start_card(priv) != 0) {
                lbs_pr_err("could not activate card\n");
@@ -909,6 +913,7 @@ static void if_cs_detach(struct pcmcia_device *p_dev)
 
        libertas_stop_card(card->priv);
        libertas_remove_card(card->priv);
+       if_cs_disable_ints(card);
        if_cs_release(p_dev);
        kfree(card);