powerpc: NAND: FSL UPM: document new bindings

This patch adds documentation for the new NAND FSL UPM bindings for:

 NAND: FSL-UPM: add multi chip support
 NAND: FSL-UPM: Add wait flags to support board/chip specific delays

It also documents the old binding for "chip-delay".

Signed-off-by: Wolfgang Grandegger <wg@grandegger.com>
Acked-by: Anton Vorontsov <avorontsov@ru.mvista.com>
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>

diff --git a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
index 84a04d5eb8e6d76c188e44378b705c5d19604568..a48b2cadc7f08fd4203bbf67f12f3afed3f447ed 100644 (file)
--- a/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
+++ b/Documentation/powerpc/dts-bindings/fsl/upm-nand.txt
@@ -5,9 +5,21 @@ Required properties:
 - reg : should specify localbus chip select and size used for the chip.
 - fsl,upm-addr-offset : UPM pattern offset for the address latch.
 - fsl,upm-cmd-offset : UPM pattern offset for the command latch.
-- gpios : may specify optional GPIO connected to the Ready-Not-Busy pin.
 
-Example:
+Optional properties:
+- fsl,upm-wait-flags : add chip-dependent short delays after running the
+       UPM pattern (0x1), after writing a data byte (0x2) or after
+       writing out a buffer (0x4).
+- fsl,upm-addr-line-cs-offsets : address offsets for multi-chip support.
+       The corresponding address lines are used to select the chip.
+- gpios : may specify optional GPIOs connected to the Ready-Not-Busy pins
+       (R/B#). For multi-chip devices, "n" GPIO definitions are required
+       according to the number of chips.
+- chip-delay : chip dependent delay for transfering data from array to
+       read registers (tR). Required if property "gpios" is not used
+       (R/B# pins not connected).
+
+Examples:
 
 upm@1,0 {
        compatible = "fsl,upm-nand";
@@ -26,3 +38,26 @@ upm@1,0 {
                };
        };
 };
+
+upm@3,0 {
+       #address-cells = <0>;
+       #size-cells = <0>;
+       compatible = "tqc,tqm8548-upm-nand", "fsl,upm-nand";
+       reg = <3 0x0 0x800>;
+       fsl,upm-addr-offset = <0x10>;
+       fsl,upm-cmd-offset = <0x08>;
+       /* Multi-chip NAND device */
+       fsl,upm-addr-line-cs-offsets = <0x0 0x200>;
+       fsl,upm-wait-flags = <0x5>;
+       chip-delay = <25>; // in micro-seconds
+
+       nand@0 {
+               #address-cells = <1>;
+               #size-cells = <1>;
+
+               partition@0 {
+                           label = "fs";
+                           reg = <0x00000000 0x10000000>;
+               };
+       };
+};