goto fsm_start;
}
-/**
- * atapi_packet_task - Write CDB bytes to hardware
- * @_data: Port to which ATAPI device is attached.
- *
- * When device has indicated its readiness to accept
- * a CDB, this function is called. Send the CDB.
- * If DMA is to be performed, exit immediately.
- * Otherwise, we are in polling mode, so poll
- * status under operation succeeds or fails.
- *
- * LOCKING:
- * Kernel thread context (may sleep)
- */
-
-static void atapi_packet_task(void *_data)
-{
- struct ata_port *ap = _data;
- struct ata_queued_cmd *qc;
- u8 status;
-
- qc = ata_qc_from_tag(ap, ap->active_tag);
- WARN_ON(qc == NULL);
- WARN_ON(!(qc->flags & ATA_QCFLAG_ACTIVE));
-
- /* sleep-wait for BSY to clear */
- DPRINTK("busy wait\n");
- if (ata_busy_sleep(ap, ATA_TMOUT_CDB_QUICK, ATA_TMOUT_CDB)) {
- qc->err_mask |= AC_ERR_TIMEOUT;
- goto err_out;
- }
-
- /* make sure DRQ is set */
- status = ata_chk_status(ap);
- if ((status & (ATA_BUSY | ATA_DRQ)) != ATA_DRQ) {
- qc->err_mask |= AC_ERR_HSM;
- goto err_out;
- }
-
- /* send SCSI cdb */
- DPRINTK("send cdb\n");
- WARN_ON(qc->dev->cdb_len < 12);
-
- if (qc->tf.protocol == ATA_PROT_ATAPI_DMA ||
- qc->tf.protocol == ATA_PROT_ATAPI_NODATA) {
- unsigned long flags;
-
- /* Once we're done issuing command and kicking bmdma,
- * irq handler takes over. To not lose irq, we need
- * to clear NOINTR flag before sending cdb, but
- * interrupt handler shouldn't be invoked before we're
- * finished. Hence, the following locking.
- */
- spin_lock_irqsave(&ap->host_set->lock, flags);
-#warning FIXME
- /* ap->flags &= ~ATA_FLAG_NOINTR; */
- ata_data_xfer(ap, qc->cdb, qc->dev->cdb_len, 1);
- if (qc->tf.protocol == ATA_PROT_ATAPI_DMA)
- ap->ops->bmdma_start(qc); /* initiate bmdma */
- spin_unlock_irqrestore(&ap->host_set->lock, flags);
- } else {
- ata_data_xfer(ap, qc->cdb, qc->dev->cdb_len, 1);
-
- /* PIO commands are handled by polling */
- ap->hsm_task_state = HSM_ST;
- ata_port_queue_task(ap, ata_pio_task, ap, 0);
- }
-
- return;
-
-err_out:
- ata_poll_qc_complete(qc);
-}
-
/**
* ata_qc_timeout - Handle timeout of queued command
* @qc: Command that timed out