iwl3945: do not delay hardware scan if it is a direct scan

iwl3945 <---> mac80211 <----> wpa_supplicant <---> NetworkManager

When a hardware scan is completed and another scan is requested in less
than two seconds, iwlwifi will not do the second scan and will pass the
error code -EAGAIN back to mac80211 where it quickly dies. The error
code is not passed along to the calling program wpa_supplicant. After a
timeout, wpa_supplicant will just give up but it will not know why the
scan failed. This is a weakness in the design.

I ran into this issue when I was trying to figure out why it takes more
an a minute for NetworkManager to connect after Networking has been
disabled and then re-enabled. I found a good deal of unnecessary work
being done because mac80211 requests authentication when the interface
is not configured, the ANY mode. I created an experimental passive
(NOTANY) mode for mac80211 to eliminate this case. Then NetworkManager
became so fast that I ran into the iwlwifi 2 second delay next scan
issue which we are discussing.

The patch resolves the problem by bypassing the delay if the scan request
is a direct scan. It should do less harm to the hardware.

Signed-off-by: Bill Moss <bmoss@CLEMSON.EDU>
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>

diff --git a/drivers/net/wireless/iwlwifi/iwl3945-base.c b/drivers/net/wireless/iwlwifi/iwl3945-base.c
index f021eba41e6a9732f3d09b0bd11ec8c5415b7ceb..4baa185ba500abe6d0418b34edfc7ffd0fa25a43 100644 (file)
--- a/drivers/net/wireless/iwlwifi/iwl3945-base.c
+++ b/drivers/net/wireless/iwlwifi/iwl3945-base.c
@@ -7087,9 +7087,10 @@ static int iwl3945_mac_hw_scan(struct ieee80211_hw *hw, u8 *ssid, size_t len)
                rc = -EAGAIN;
                goto out_unlock;
        }
-       /* if we just finished scan ask for delay */
-       if (priv->last_scan_jiffies && time_after(priv->last_scan_jiffies +
-                               IWL_DELAY_NEXT_SCAN, jiffies)) {
+       /* if we just finished scan ask for delay for a broadcast scan */
+       if ((len == 0) && priv->last_scan_jiffies &&
+           time_after(priv->last_scan_jiffies + IWL_DELAY_NEXT_SCAN,
+                      jiffies)) {
                rc = -EAGAIN;
                goto out_unlock;
        }