netdev: convert cs89x0 to net_device_ops

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/cs89x0.c b/drivers/net/cs89x0.c
index ff6497658a4538c94ceff39898c5b74f7f75da86..7433b88eed7e958f0666d02bafac62657add0bc0 100644 (file)
--- a/drivers/net/cs89x0.c
+++ b/drivers/net/cs89x0.c
@@ -501,6 +501,21 @@ static void net_poll_controller(struct net_device *dev)
 }
 #endif
 
+static const struct net_device_ops net_ops = {
+       .ndo_open               = net_open,
+       .ndo_stop               = net_close,
+       .ndo_tx_timeout         = net_timeout,
+       .ndo_start_xmit         = net_send_packet,
+       .ndo_get_stats          = net_get_stats,
+       .ndo_set_multicast_list = set_multicast_list,
+       .ndo_set_mac_address    = set_mac_address,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+       .ndo_poll_controller    = net_poll_controller,
+#endif
+       .ndo_change_mtu         = eth_change_mtu,
+       .ndo_validate_addr      = eth_validate_addr,
+};
+
 /* This is the real probe routine.  Linux has a history of friendly device
    probes on the ISA bus.  A good device probes avoids doing writes, and
    verifies that the correct device exists and functions.
@@ -843,17 +858,8 @@ cs89x0_probe1(struct net_device *dev, int ioaddr, int modular)
        /* print the ethernet address. */
        printk(", MAC %pM", dev->dev_addr);
 
-       dev->open               = net_open;
-       dev->stop               = net_close;
-       dev->tx_timeout         = net_timeout;
-       dev->watchdog_timeo     = HZ;
-       dev->hard_start_xmit    = net_send_packet;
-       dev->get_stats          = net_get_stats;
-       dev->set_multicast_list = set_multicast_list;
-       dev->set_mac_address    = set_mac_address;
-#ifdef CONFIG_NET_POLL_CONTROLLER
-       dev->poll_controller    = net_poll_controller;
-#endif
+       dev->netdev_ops = &net_ops;
+       dev->watchdog_timeo = HZ;
 
        printk("\n");
        if (net_debug)