xircom: convert devices to new API

Convert to net_device_ops and internal net_device_stats

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/tulip/xircom_cb.c b/drivers/net/tulip/xircom_cb.c
index 13c8703ecb9f0794e4ca718797a8ea0ea3ef8ed9..c2ca9f40e40e96929bb4254ce0d13848b9f477d7 100644 (file)
--- a/drivers/net/tulip/xircom_cb.c
+++ b/drivers/net/tulip/xircom_cb.c
@@ -104,10 +104,8 @@ struct xircom_private {
         */
        spinlock_t lock;
 
-
        struct pci_dev *pdev;
        struct net_device *dev;
-       struct net_device_stats stats;
 };
 
 
@@ -119,7 +117,6 @@ static int xircom_start_xmit(struct sk_buff *skb, struct net_device *dev);
 static int xircom_open(struct net_device *dev);
 static int xircom_close(struct net_device *dev);
 static void xircom_up(struct xircom_private *card);
-static struct net_device_stats *xircom_get_stats(struct net_device *dev);
 #ifdef CONFIG_NET_POLL_CONTROLLER
 static void xircom_poll_controller(struct net_device *dev);
 #endif
@@ -194,6 +191,18 @@ static const struct ethtool_ops netdev_ethtool_ops = {
        .get_drvinfo            = netdev_get_drvinfo,
 };
 
+static const struct net_device_ops netdev_ops = {
+       .ndo_open               = xircom_open,
+       .ndo_stop               = xircom_close,
+       .ndo_start_xmit         = xircom_start_xmit,
+       .ndo_change_mtu         = eth_change_mtu,
+       .ndo_set_mac_address    = eth_mac_addr,
+       .ndo_validate_addr      = eth_validate_addr,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+       .ndo_poll_controller    = xircom_poll_controller,
+#endif
+};
+
 /* xircom_probe is the code that gets called on device insertion.
    it sets up the hardware and registers the device to the networklayer.
 
@@ -266,13 +275,7 @@ static int __devinit xircom_probe(struct pci_dev *pdev, const struct pci_device_
        read_mac_address(private);
        setup_descriptors(private);
 
-       dev->open = &xircom_open;
-       dev->hard_start_xmit = &xircom_start_xmit;
-       dev->stop = &xircom_close;
-       dev->get_stats = &xircom_get_stats;
-#ifdef CONFIG_NET_POLL_CONTROLLER
-       dev->poll_controller = &xircom_poll_controller;
-#endif
+       dev->netdev_ops = &netdev_ops;
        SET_ETHTOOL_OPS(dev, &netdev_ethtool_ops);
        pci_set_drvdata(pdev, dev);
 
@@ -497,14 +500,6 @@ static int xircom_close(struct net_device *dev)
 }
 
 
-
-static struct net_device_stats *xircom_get_stats(struct net_device *dev)
-{
-        struct xircom_private *card = netdev_priv(dev);
-        return &card->stats;
-}
-
-
 #ifdef CONFIG_NET_POLL_CONTROLLER
 static void xircom_poll_controller(struct net_device *dev)
 {
@@ -1193,7 +1188,7 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri
 
                        skb = dev_alloc_skb(pkt_len + 2);
                        if (skb == NULL) {
-                               card->stats.rx_dropped++;
+                               dev->stats.rx_dropped++;
                                goto out;
                        }
                        skb_reserve(skb, 2);
@@ -1201,8 +1196,8 @@ static void investigate_read_descriptor(struct net_device *dev,struct xircom_pri
                        skb_put(skb, pkt_len);
                        skb->protocol = eth_type_trans(skb, dev);
                        netif_rx(skb);
-                       card->stats.rx_packets++;
-                       card->stats.rx_bytes += pkt_len;
+                       dev->stats.rx_packets++;
+                       dev->stats.rx_bytes += pkt_len;
 
                      out:
                        /* give the buffer back to the card */
@@ -1232,16 +1227,16 @@ static void investigate_write_descriptor(struct net_device *dev, struct xircom_p
 #endif
                if (status > 0) {       /* bit 31 is 0 when done */
                        if (card->tx_skb[descnr]!=NULL) {
-                               card->stats.tx_bytes += card->tx_skb[descnr]->len;
+                               dev->stats.tx_bytes += card->tx_skb[descnr]->len;
                                dev_kfree_skb_irq(card->tx_skb[descnr]);
                        }
                        card->tx_skb[descnr] = NULL;
                        /* Bit 8 in the status field is 1 if there was a collision */
                        if (status&(1<<8))
-                               card->stats.collisions++;
+                               dev->stats.collisions++;
                        card->tx_buffer[4*descnr] = 0; /* descriptor is free again */
                        netif_wake_queue (dev);
-                       card->stats.tx_packets++;
+                       dev->stats.tx_packets++;
                }
 
                leave("investigate_write_descriptor");