]> pilppa.com Git - linux-2.6-omap-h63xx.git/commitdiff
rtl8187: Change detection of RTL8187B with USB ID of 8187
authorLarry Finger <Larry.Finger@lwfinger.net>
Tue, 8 Jul 2008 14:43:43 +0000 (09:43 -0500)
committerJohn W. Linville <linville@tuxdriver.com>
Tue, 8 Jul 2008 18:16:07 +0000 (14:16 -0400)
Some early versions of RTL8187B devices have a USB ID of 0x8187
rather than the 0x8189 of later models. In addition, it appears
that these early units also must be programmed with lower power.
Previous patches used the Product ID string to detect this situation,
but did not address the low power question. This patch uses the
hardware version and sets the power accordingly.

Signed-off-by: Hin-Tak Leung <htl10@users.sourceforge.net>
Signed-off-by: Larry Finger <Larry.Finger@lwfinger.net>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
drivers/net/wireless/rtl8187_dev.c
drivers/net/wireless/rtl818x.h

index 3bc4a1c392587c356a34ca0d991c946fa9b3c34d..33527e58256fb439d2f188933ec3b2dd8ec35087 100644 (file)
@@ -981,8 +981,7 @@ static int __devinit rtl8187_probe(struct usb_interface *intf,
        }
 
        priv = dev->priv;
-       priv->is_rtl8187b = (id->driver_info == DEVICE_RTL8187B) ||
-                           !memcmp(udev->product, "RTL8187B", 8);
+       priv->is_rtl8187b = (id->driver_info == DEVICE_RTL8187B);
 
        SET_IEEE80211_DEV(dev, &intf->dev);
        usb_set_intfdata(intf, dev);
@@ -1011,13 +1010,6 @@ static int __devinit rtl8187_probe(struct usb_interface *intf,
        dev->flags = IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING |
                     IEEE80211_HW_RX_INCLUDES_FCS |
                     IEEE80211_HW_SIGNAL_UNSPEC;
-       dev->extra_tx_headroom = (!priv->is_rtl8187b) ?
-                                 sizeof(struct rtl8187_tx_hdr) :
-                                 sizeof(struct rtl8187b_tx_hdr);
-       if (!priv->is_rtl8187b)
-               dev->queues = 1;
-       else
-               dev->queues = 4;
        dev->max_signal = 65;
 
        eeprom.data = dev;
@@ -1052,26 +1044,6 @@ static int __devinit rtl8187_probe(struct usb_interface *intf,
                (*channel++).hw_value = txpwr & 0xFF;
                (*channel++).hw_value = txpwr >> 8;
        }
-       if (!priv->is_rtl8187b) {
-               for (i = 0; i < 2; i++) {
-                       eeprom_93cx6_read(&eeprom,
-                                         RTL8187_EEPROM_TXPWR_CHAN_6 + i,
-                                         &txpwr);
-                       (*channel++).hw_value = txpwr & 0xFF;
-                       (*channel++).hw_value = txpwr >> 8;
-               }
-       } else {
-               eeprom_93cx6_read(&eeprom, RTL8187_EEPROM_TXPWR_CHAN_6,
-                                 &txpwr);
-               (*channel++).hw_value = txpwr & 0xFF;
-
-               eeprom_93cx6_read(&eeprom, 0x0A, &txpwr);
-               (*channel++).hw_value = txpwr & 0xFF;
-
-               eeprom_93cx6_read(&eeprom, 0x1C, &txpwr);
-               (*channel++).hw_value = txpwr & 0xFF;
-               (*channel++).hw_value = txpwr >> 8;
-       }
 
        eeprom_93cx6_read(&eeprom, RTL8187_EEPROM_TXPWR_BASE,
                          &priv->txpwr_base);
@@ -1090,17 +1062,20 @@ static int __devinit rtl8187_probe(struct usb_interface *intf,
                reg32 = rtl818x_ioread32(priv, &priv->map->TX_CONF);
                reg32 &= RTL818X_TX_CONF_HWVER_MASK;
                switch (reg32) {
-               case RTL818X_TX_CONF_R8187vD_1:
-               case RTL818X_TX_CONF_R8187vD_2:
+               case RTL818X_TX_CONF_R8187vD_B:
+                       /* Some RTL8187B devices have a USB ID of 0x8187
+                        * detect them here */
+                       chip_name = "RTL8187BvB(early)";
+                       priv->is_rtl8187b = 1;
+                       priv->hw_rev = RTL8187BvB;
+                       break;
+               case RTL818X_TX_CONF_R8187vD:
                        chip_name = "RTL8187vD";
                        break;
                default:
                        chip_name = "RTL8187vB (default)";
                }
        } else {
-               printk(KERN_WARNING "rtl8187: 8187B chip detected. Support "
-                       "is EXPERIMENTAL, and could damage your\n"
-                       "         hardware, use at your own risk\n");
                /*
                 * Force USB request to write radio registers for 8187B, Realtek
                 * only uses it in their sources
@@ -1129,7 +1104,43 @@ static int __devinit rtl8187_probe(struct usb_interface *intf,
                }
        }
 
+       if (!priv->is_rtl8187b) {
+               for (i = 0; i < 2; i++) {
+                       eeprom_93cx6_read(&eeprom,
+                                         RTL8187_EEPROM_TXPWR_CHAN_6 + i,
+                                         &txpwr);
+                       (*channel++).hw_value = txpwr & 0xFF;
+                       (*channel++).hw_value = txpwr >> 8;
+               }
+       } else {
+               eeprom_93cx6_read(&eeprom, RTL8187_EEPROM_TXPWR_CHAN_6,
+                                 &txpwr);
+               (*channel++).hw_value = txpwr & 0xFF;
+
+               eeprom_93cx6_read(&eeprom, 0x0A, &txpwr);
+               (*channel++).hw_value = txpwr & 0xFF;
+
+               eeprom_93cx6_read(&eeprom, 0x1C, &txpwr);
+               (*channel++).hw_value = txpwr & 0xFF;
+               (*channel++).hw_value = txpwr >> 8;
+       }
+
+       if (priv->is_rtl8187b)
+               printk(KERN_WARNING "rtl8187: 8187B chip detected. Support "
+                       "is EXPERIMENTAL, and could damage your\n"
+                       "         hardware, use at your own risk\n");
+       if ((id->driver_info == DEVICE_RTL8187) && priv->is_rtl8187b)
+               printk(KERN_INFO "rtl8187: inconsistency between id with OEM"
+                      " info!\n");
+
        priv->rf = rtl8187_detect_rf(dev);
+       dev->extra_tx_headroom = (!priv->is_rtl8187b) ?
+                                 sizeof(struct rtl8187_tx_hdr) :
+                                 sizeof(struct rtl8187b_tx_hdr);
+       if (!priv->is_rtl8187b)
+               dev->queues = 1;
+       else
+               dev->queues = 4;
 
        err = ieee80211_register_hw(dev);
        if (err) {
index 85a6394e4309a2fbfab364c59026e747bfb38540..00900fe16fce5ae6e515de2337ff3819c887ce52 100644 (file)
@@ -66,8 +66,8 @@ struct rtl818x_csr {
 #define RTL818X_TX_CONF_R8180_F                (3 << 25)
 #define RTL818X_TX_CONF_R8185_ABC      (4 << 25)
 #define RTL818X_TX_CONF_R8185_D                (5 << 25)
-#define RTL818X_TX_CONF_R8187vD_1      (5 << 25)
-#define RTL818X_TX_CONF_R8187vD_2      (6 << 25)
+#define RTL818X_TX_CONF_R8187vD                (5 << 25)
+#define RTL818X_TX_CONF_R8187vD_B      (6 << 25)
 #define RTL818X_TX_CONF_HWVER_MASK     (7 << 25)
 #define RTL818X_TX_CONF_DISREQQSIZE    (1 << 28)
 #define RTL818X_TX_CONF_PROBE_DTS      (1 << 29)